Search results

I'm currently wrapping up a year long process of replacing all stringers and the transom on a 93 252gt. all of it was rotten and water logged. don't buy it without a survey, unless you want to get into a nice project. it's a great boat, it's a great hull design and handles chop extremely well.

contact Citi marine with the dimensions and btu you need and they will find a unit that fits. I'm an AC contractor in Panama, and this is what I do when I need a new unit for clients.

it's open. that's foam in there. soaking wet foam

mine was open to the transom. 1993 sailfish 252. the lower holes for the motor bolts we threaded.

if one is working and the other is not I would suspect they are separate systems. do they have have separate switches to turn them on and off? with the helm box. is it a digital controller or a mechanical thermostat with a knob? and with the fish box. you'll need to follow the steps in my...

I'm not familiar with the exact systems in use here. but I work with marine AC and refrigeration regularly. I would think that the fish box plates and the AC are 2 separate systems. this is because a single system cannot produce both freezing temperatures for the fish box, and above freezing...

Long post inbound. I am about to embark on the transom replacement and want to run a few things by you guys before the work get started. I have a 93 Sailfish 252 with the factory transom extension. I found some rot in the upper port corner and around the drain plug of the transom and knew it...

put some food coloring in the water to make the leak easier to find.

do these refrigerators use the Danfoss BD compressor? if so, switching to AC/DC is as simple as changing the compressor controller unit. I can look up the model number if anyone is interested.

the location of the return air vent really doesn't matter in regards to the evap. as long as you can connect the blower to the register with flex duct it will work just fine. I'm not familiar with the exact setup in your boat, but in general most marine AC just sit inside a cabinet that has a...

the model and brand won't really matter. just match the btu size. most smaller marine AC units are stand alone. they just require the power and water connection. so if you had a dometic you could easily swap it out for a webasto or any other brand. I work in marine AC and refrigeration so let...

thank you all.

redoing from the inside. the interior transom glass has cracked and delaminated on the upper port side. going to cut the cap and pull it off since it has cracks on the stern section. that should give us enough access to redo everything from the inside. I'm also going to relocate the batteries...

a still from a video from above. you can see it end before the hull on the right side

hi all. so I'm getting ready for my transom rebuild on my 93 sailfish 252gt. The coosa board and roll of 1708 arrives from the states next week after almost 2 months waiting. is this cross member on the transom structural? do I need to build a new one into the new transom when I redo it? it...

do I need to bleed the lines?

the leak is somewhere in the pump module/reservoir. I can see traces of the fluid under the area of the pump. I was just wondering if a particular part/seal normally fails or if I need to dig into it and find out

hello all I recently purchased a 93 sailfish 252. it has issues that I'm working through, transom is being replaced, I've redone most of the wiring, freshwater tank had a leak, etc but my question today is about the trim tab pump reservoir. I can hear the pump activate when I press the...

first catch since I bought my Grady. 31.5lbs, 42". only hookup we had all day. we were about 2 miles offshore in 500ft of water in Bocas del Toro Panamá.