Search results

https://www.integritymarinecorp.com/product-page/f8252

Thank you both...I will work on pics today.

Hello All, I am staying busy trying to work the bugs out of my recently acquired 97 Voyager and one of the issues I have discovered is that my trim planes appear to be cupped and bent/ warped The warping/ bent is bad enough that when fully raised, the planes remain below the planing surface of...

Good stuff..Thank you. I have pulled my switch panel and have a good understanding of what is going on back there. I also located a load side ( + and -) termination below the aft hatch which are Orange with a brown tracer. After reviewing the schematics and color code chart and testing from the...

And run up the port side....That is the canundrum. This week I will be pulling the batteries out to see what is going on with/in the wire bundle back there.

I determined there was no power by cutting the brown wire off the pump and used my meter from the brown line side and the negative on the battery. I then connected both leads from the pump directly to the battery and the pump work fine.

I had mine replaced a couple months ago. A local fabricator made one over sized and heavier guage. Sealed the bejeepers out of it and it is rock solid.

I pulled my switch panel today and saw that my ACC switches, which to the best of my knowledge do nothing. However, they all have a wire coming off the load side and appear to be factory. Why? Where would I find where the ACC load wires terminate so I can use them rather than pull new wire to...

Hello all, I am hoping to find a replacement escape hatch for my new to me 1997 248 Voyager. Any input would be appreciated. Steve