Search results

Yes, that was the issue and the system is working again. Even though I had initially cleared the vent line, the hull vent itself got clogged again. This time removed the vent hose and dug around the fitting with a small screwdriver and then flushed the fitting with dockside water for about 5...

Thanks. I haven't found any Y-valve on the boat. The setup is a single head with a single discharge line. I think next I'll try to get a model number off the pump that's shown in the picture and see if I can find a diagram somewhere.

Hmm. Not sure. There are two pumps near the holding and vacuum reservoir. One is the vacuum pump (off to the right). I changed the duck bills last year on it so I know it's not the macerator. I'm assuming one unit on top is the macerator but it doesn't look like a typical Jabsco macerator. Maybe...

Thanks, I'll check it again.

I have a new problem on my 2007 330 Express with a factory Vacu-Flush system. I had a clogged holding tank vent line (recently-installed and quickly failed charcoal odor filter, since removed and vent fixed) which temporarily pressurized the holding tank, and since that time, when the head is...

Thanks Seasick,, good to know. I'm thinking the shrink tubing everywhere should keep the soldered connections sufficiently firm (as they have in the past for me) but I will keep that in mind for my next project!

I got tired of sticking my head into the generator comparment and trying to read that lousy dial gauge on top of the tank, so here is the installation procedure (and parts needed) to get a gauge up on the helm dashboard...

Parts: Fuel Sender: KUS 33-240 ohm model KUS-SSL20 (fisheriessupply.com) with cork gasket or optional nitrile gasket, model KUS JSR00181. Wire: 50 feet of red-yellow-black 16awg jacketed wire (Amazon #B0CX1DBFDP). I really wanted just yellow and black 16AWG conductors but I was unable to find...

My 2007 Fischer Panda generator on my 330 Express developed an issue last August 2024. After running great for 60+ hours last season, it started shutting down after approx. four minutes due to an overheat issue. The Engine Temp idiot light would turn red each time it shut down. Having owned a...

2007 330 Express Original Factory TV and Antenna Replacement TV REPLACEMENT: I removed the old analog “4:3” TV that came with the boat and installed a new smart TV, a 22” Insignia model. For mounting, I bolted the existing TV pivot arm to a 14”x11.75”x3/4" piece of Starboard (HDPE material)...

Great description; I'll try to change mine on my 2007 330 tomorrow (first season with this boat so I'm learning as I go). Can you describe where that filter screen nut is? The manual doesn't show the location and only has a closeup of the nut. Thanks

Where was that aftermarket antenna "cylinder" located? Was it in the compartment behind the TV?

I'm trying to locate the TV antenna on my 2007 330 Express. No sign of it on the hardtop or elsewhere . The GW documentation just mentions a "broadcast antenna" without specifying a location. I'm guessing this is just an unamplified antenna as I don't see any 12V antenna feed reference in the...