Search results

Check the tires, spare and wheel bearings. You may want to invest in an infrared temp gun and check tires and bearings a couple times in the trip. Good luck, John

jjblbi John 1991 Gulfstream 232G 2001 Yamaha 250hp OX-66

I replaced my Gulfstream senders and gauge with WEMA as well, very happy. One thing I did do was but a HF pneumatic right angle drill for sender screw removal. Quite the pucker factor doing the job in the Spring on top of two full tanks!

I've seen two pieces of corrugated hose ripped lenth wise and put on top of each other with the seams 180 degrees apart. Zip-tie every 3-4 inches.

is the primer bulb hard? Fuel filters OK? Make sure the kill switch is hooked up. A quick blast of starting fluid while cranking will let you know if you are gitteing spark. If these check out pull an injector and check spray pattern. Good luck, John

I too have the faded trim. Armor All works for about a month. Has anyone tried composite decking ripped down or does it belly like starboard? Thanks, John

Sorry i'm getting to this thread so late...I repaired my 232G bracket "coating" with white spray-on truck bed bed liner. Be sure to clean the area well, cut back the coating to fully adhered spots and spray on 4 or 5 coats. My has lasted 2+ years in salt water all season. The stuff is pretty...

When I drained the bowl I got 100% gas. JOHN

Walt, except for that one fuel issue she has and is running great. Your carmel colored description is more accurate than my sh*t description. I also started using Startron per the label dosage. I added an hour meter in the cabin the first season and last winter added two Wema fuel senders...

I had fuel problems earlier this season and although the clear bowl didn't show anything I drained it several times. As problems persisted I changed my low pressure pumps and all filters. When I took off the main filter and bowl (still clear) I dumped it into a coffee can and 1/2 was water &...

My '91 Gulfstream's bracket has some type of vinyl coating almost as if it was dipped. I cut open some blisters and cleaned the areas then applied several coats of white spray on truck bed liner. Two years no problems. If I had to start from scratch I would consider this type of coating...