Search results

I took the striping off of my voyager and did not replace . I think it looks better . I used a heat gun to remove the strips , then used a turtle wax adhesive remover ( walmart ) to get the residue off . After the strips are removed spray the turtle wax on and wait two minuets then scrape with a...

I cant wait to here more results . I have a voyager with 2 stroke yam 250 and it runs great .

I had a 87 overnighter and replaced the 65 gal alum with a 45 gal poly . I moved the tank as far forward in the compartment as possible and secured it with redwood 2x4`s you might as well change the fuel lines as well . it was a great move and now you dont have to worry about the alum tank from...

I love my voyager . I live in California and bought my 96 voyager used from Florida in near mint condition for $17000 it has a single yamaha SWS two 250 and runs great. The fit between the helm chairs is a bit narrow so I took the arm rests off the captains chairs and that made it much better...

I just got my 1996 248 Voyager in october after having a 204C overnighter for 7 years . I have a single yam 250 it has a very dry ride with the sea V 2 hull .

What about the Spark plug wires . There should be voltage at the end of the wire that fires the spark plug .

Nice job , I have looked all over the web to find new ones for my boat and cant find anywhere .

The new hole connected to the old hole since I only needed an extra inch or so to get the old one out and the new one in . More like an oblong hole . I used a router bit 1/4" shank in a die grinder to cut out the hole .The router bit will cut through fiberglass like butter .

Let me tell you guys about my old boat . I tig welded the whole house out of 5/16" Alum and mounted it to the 2" wide flange that the old windshield was attached to , just like a camper shell mounts to the bed of a truck . It was tough as a brick S@^# House . In fact I took the lip of a 7'-8'...

I had a Overnighter with the same problem I cut a hole in the side of the motor well , so I could remove and install the new cable in without lifting the motor then just patch the hole with a cover or fiberglass . With cable steering you will have this problem every three or four years because...

They all had the same gap one looked a little dryer then the rest but none were overly oily or burnt . I am going to replace the electric fuel pump when I turn the key to the on position the pump makes a heck of a rattling noise . Other than that she runs good .

Fixed the problem .Before I could only get to 4000 RPM and then the motor would surge a little 300-400 RPM from 3600 to 4000. I replaced all the Spark Plugs and that fixed it no more surging .

I am putting in new spark plugs, the motor is a 1996 I have no idea if they have ever been changed . The book says 4500 to 5500 max RPMs . There of course was fuel in the tank when I got the boat not sure about the condition but I did clean out the fuel filter under the cover and changed the...

I have a 1996 248 Voyager that came with a Yamaha Carbureted SW Series II 250 HP outboard . The boat is a few months new to me . Both boat and motor are in Excellent condition however I can not get the motor to get over 4000-4100 RPM .The prop is a SS 14.250 x 17 . Motor is a S250TURU . I am not...