What's up guys. I am getting to the point where I need to replace the coaming bolsters on my 2002 Grady White 282 Sailfish. I was looking into installing some of the pre made foam bolsters from Overtons (Seadek Coaming Bolster Pad Set) or a Similar product. I'm just a little curious if anybody has used these and if the dimensions are ok. They say they are 4.5" wide and this does not seem like it would be wide enough. Any thoughts would be helpful.
Coaming Bolster
- Thread starter OGBobbyG
- Start date
Fishtales
Well-Known Member
- Joined
- Jan 31, 2005
- Messages
- 8,232
- Reaction score
- 1,344
- Points
- 113
Fishtales
Well-Known Member
- Joined
- Jan 31, 2005
- Messages
- 8,232
- Reaction score
- 1,344
- Points
- 113
Bolster and Seat Recover
I decided to tackle this job over the winter. So before putting away for the season, I removed the (6) piece bolster set, the aft seat and the companion seat from my 300 Marlin. Not doing this type of work before, I read up on it on this site as well as sailrite and youtube. This thread will...
www.greatgrady.com