install new stainless thru hull

[rnorrk]

finally done they were a bit trickey hardest one was port side trying to line it up and thread it into a fitting i had cut off the barbed end on the new thru hull best way is a die grinder only 2 like this the rest were just sliding it onto hose and you do need a second person next on the list new radar =rewire = new charging relay hope these pics help

 

[richmake]

I just did the same thing...used a wrench one the inside adn wendged it against the hull...ran around to the outside and cranked it down...not an easy job all in all but do-able...

 

[Rickysa]

You had better luck than me!

I'm still bruised from wrist to shoulder from doing mine last week...what a biyatch. Still have one to go, and I'm dreading it.