Latest activity

  • Hookup1
    Hookup1 replied to the thread pulpit.
    Some high stress attachments like cleats, awning track, bow pulpits and swim platforms should be bedded. The constant stress of flexing...
  • Sardinia306Canyon
    Sardinia306Canyon replied to the thread Starter help!!.
    Measure voltage on the starter when "cranking", not the batteries. You could apply 12V directly to the starter 12V poles making two new...
  • Sardinia306Canyon
    Sardinia306Canyon reacted to Hookup1's post in the thread Starter help!! with Like Like.
    What does “checked batteries there good” mean? Tight connections are important but I would bet on bad battery. How old is it...
  • F
    family affair reacted to seasick's post in the thread Starter help!! with Like Like.
    On the starter relay, there will be two smaller terminals two fatter terminals; One from the battery +12v and the second which goes to...
  • H
    Halfhitch reacted to seasick's post in the thread Starter help!! with Like Like.
    On the starter relay, there will be two smaller terminals two fatter terminals; One from the battery +12v and the second which goes to...
  • Hookup1
    Hookup1 replied to the thread Starter help!!.
    Check kill switch lanyard clipped in. Make sure shift is in neutral. Clip volt meter to ground and small lug on engine starter...
  • 4
    49pan replied to the thread pulpit.
    well i finally got it off. It was loaded with 5200. KI had to lift and slice with a fillet knife. But it came off I won't be using 5200...
  • S
    seasick replied to the thread Starter help!!.
    On the starter relay, there will be two smaller terminals two fatter terminals; One from the battery +12v and the second which goes to...
  • M
    mg1826 reacted to wspitler's post in the thread Cockpit Scupper Access with Like Like.
    Thanks! My diesel tank gets in the way if working from the bilge.
  • W
    wspitler replied to the thread Cockpit Scupper Access.
    Thanks! My diesel tank gets in the way if working from the bilge.
  • JJF
    JJF replied to the thread Choosing the right grady..
    I have a 306 Canyon, which is the same hull as the 307. The boat is very stable at anchor and in the drift. It runs very well in most...
  • JJF
    JJF reacted to Sardinia306Canyon's post in the thread Honda BF350 on Canyon 306 with Like Like.
    The photo below is from yesterday, today we finished 99% of cabeling, steering pistons, i guess we will drop her next week: I installed...
  • J
    JoeSmo209 replied to the thread Starter help!!.
    How does one check the stater relay?
  • H
    Halfhitch reacted to journeyman's post in the thread Windlass kit with Like Like.
    I would find out how Grady wires a windlass on your boat. Should be able to see from the diagram in the owner's manual. If you don't run...
  • Mustang65fbk
    Mustang65fbk replied to the thread Starter help!!.
    Per the OP's second post, the batteries are a year old