Latest activity

What's new Featured content New posts New media New media comments New profile posts Latest activity
  • S
    seasick replied to the thread Forward Bilge pump float question.
    The pumps two modes of operation are individually fed. The manual mode gets power from the accessory bus which is live when the battery...
  • F
    frankm replied to the thread 305 Listing.
    My 305 also slightly lists to port. I also attribute it to all the cabinets on the port side in the galley, as stated above.
  • Hookup1
    Hookup1 replied to the thread 12v question.
    You don’t use a transformer to reduce DC voltage. Transformers require AC. You would have to use a power converter which is an expensive...
  • Hookup1
    Hookup1 replied to the thread Forward Bilge pump float question.
    If the pump runs using the manual bilge pump switch all your wiring is good. The float switch is in parallel and all the wiring is right...
  • J
    JohnL posted the thread Forward Bilge pump float question in General Discussion.
    I have a 1990 24 Offshore, and my forward bilge pump works when I use the manual switch. However, when I lift the float switch, I hear...
  • Seafarer_Bob
    Seafarer_Bob posted the thread 12v question in Tips, Modifications and Electronics.
    I'm thinking about connecting my 36v trolling motor batteries to my 12v house for more capacity, anyone do this? The 36v / 60AH...
  • Seafarer_Bob
    Seafarer_Bob replied to the thread NJ fishing reports.
    Last Saturday morning on the Shrewsbury river there were boats trolling right behind my brother's house. Ran up the Navasync, netted...
    • 20260503_073712.jpg
    • Screenshot_20260502_195953_Messages.jpg
  • Hookup1
    Hookup1 replied to the thread Fuel level measurement.
    I would expect that your new Suzuki motors track fuel burn. Your gauges may not report fuel burn. But newer chartplotter can be...
  • D
    DA1977 replied to the thread Scupper hoses.
    Attaching some pics to show the condition of the transom.
    • IMG_7107.jpeg
    • IMG_7114.jpeg
    • IMG_7115.jpeg
    • IMG_7116.jpeg
  • D
    DA1977 replied to the thread Scupper hoses.
    Hoses look similar. Pic attached.
    • IMG_7096.jpeg
  • H
    hjbutler replied to the thread Fuel level measurement.
    LOL. Same here. But I never let it go below 1/4 tank.
  • H
    hjbutler replied to the thread Fuel level measurement.
    Yes, I'm well aware that it shows more fuel when the boat is bow up.
  • H
    hjbutler replied to the thread Fuel level measurement.
    I am going to do this. That will at least give me a "real world" reference.
  • H
    hjbutler replied to the thread Fuel level measurement.
    My engine does not have a computer.
  • H
    hjbutler replied to the thread Fuel level measurement.
    Thanks for the idea. I noticed that they have specific Ohm readings for levels. I may put a meter on the sender and see if the Ohm...
Show older items