Latest activity

What's new Featured content New posts New media New media comments New profile posts Latest activity
  • B
    boater36 replied to the thread Freedom 235 Drain Plug Question.
    Yes, pipe thread plugs always stick out some. Does not need to be super tight either- finger tight plus maybe a half turn. I keep an...
  • Msp381
    Msp381 commented on stadams's profile post.
    What's your offer? I only have one that has both arms rests that attaches to the bottom side. It can go on either port or starboard...
  • W
    wspitler replied to the thread Floor drain hoses.
    Search scupper drains, scupper hoses, etc. Check out: Replacing cockpit floor drains Thread starter ocdansar Start Nov 22, 2020
  • S
    stadams left a message on Msp381's profile.
    Hi there, thanks for the prompt response. Please let me know what you need for them. Appreciate it. My email is stadams08@gmail.com
  • S
    stadams left a message on Msp381's profile.
    Hi there, thanks for the prompt response. Please let me know what you need for them. Appreciate it. My email is stadams08@gmail.com
  • Msp381
    Msp381 replied to the thread Arms for 257 Journey chairs.
    I have one set of arms from a 228 seafarer if your interested. They are in excellent condition and can send a picture. Send me a PM...
  • A
    alfredbell replied to the thread Floor drain hoses.
    Apologies. I need to improve my search skills. I wasn't able to find anything. Will look again. In the meantime, many thanks!
  • S
    seasick replied to the thread Freedom 235 Drain Plug Question.
    On brass plugs, I apply a few turns of tape. It make tightness easier to judge and more importantly, it makes it easier to pull the plug...
  • D
    DennisG01 replied to the thread Freedom 235 Drain Plug Question.
    Adding onto that... Because bronze is a soft metal it seals very well on it's own without any tape/goop/etc - not that it's bad to use...
  • W
    wotblake replied to the thread Freedom 235 Drain Plug Question.
    Thank you for Thank you for the response! I have no need to remove it right now. I just wasn't sure if there is any chance of it...
  • D
    DennisG01 replied to the thread Engine Flush Adapter no longer sold by Grady.
    While it can still be done, it's a lot harder to use the muffs if the boat is in the water. Secondly, using either the built-in hose...
  • W
    wspitler replied to the thread Floor drain hoses.
    Many posts on this. Port side may be doable with batteries removed, starboard side, nearly impossible without cutting. could remove the...
  • W
    wspitler replied to the thread Freedom 235 Drain Plug Question.
    It’s probably fine. That is a tapered, brass fitting (NPT). It will not completely seat, if it was me, I would remove it, clean the...
  • W
    wotblake posted the thread Freedom 235 Drain Plug Question in General Discussion.
    Long time lurker, first post. I just bought my first boat - a used Freedom 235. I was working on it today and notice several threads of...
    • transom plug.JPG
  • S
    seasick replied to the thread Engine Flush Adapter no longer sold by Grady.
    The legacy plumbing for plumbing is a real pain to use especially when, as mentioned, you have two motors close to each other. One of my...
Show older items