Latest activity

What's new Featured content New posts New media New media comments New profile posts Latest activity
  • F
    family affair reacted to Hookup1's post in the thread 1997 Islander 268 Transom Rebuild Project with Like Like.
    Project finished! I'll add a photo of the splashwell when the motor harness is hooked up. AwlCraft 2000 paint is amazing! That finish is...
  • Ekea
    Ekea reacted to davisjohnson200's post in the thread Engine Flush Adapter no longer sold by Grady with Like Like.
    Ekea, the engines are very close to together on my Freedom 275 and it is hard to reach the flush adapter on one of them, and it takes a...
  • B
    boater36 replied to the thread Freedom 235 Drain Plug Question.
    Yes, pipe thread plugs always stick out some. Does not need to be super tight either- finger tight plus maybe a half turn. I keep an...
  • Msp381
    Msp381 commented on stadams's profile post.
    What's your offer? I only have one that has both arms rests that attaches to the bottom side. It can go on either port or starboard...
  • W
    wspitler replied to the thread Floor drain hoses.
    Search scupper drains, scupper hoses, etc. Check out: Replacing cockpit floor drains Thread starter ocdansar Start Nov 22, 2020
  • S
    stadams left a message on Msp381's profile.
    Hi there, thanks for the prompt response. Please let me know what you need for them. Appreciate it. My email is stadams08@gmail.com
  • S
    stadams left a message on Msp381's profile.
    Hi there, thanks for the prompt response. Please let me know what you need for them. Appreciate it. My email is stadams08@gmail.com
  • Msp381
    Msp381 replied to the thread Arms for 257 Journey chairs.
    I have one set of arms from a 228 seafarer if your interested. They are in excellent condition and can send a picture. Send me a PM...
  • A
    alfredbell replied to the thread Floor drain hoses.
    Apologies. I need to improve my search skills. I wasn't able to find anything. Will look again. In the meantime, many thanks!
  • S
    seasick replied to the thread Freedom 235 Drain Plug Question.
    On brass plugs, I apply a few turns of tape. It make tightness easier to judge and more importantly, it makes it easier to pull the plug...
  • D
    DennisG01 replied to the thread Freedom 235 Drain Plug Question.
    Adding onto that... Because bronze is a soft metal it seals very well on it's own without any tape/goop/etc - not that it's bad to use...
  • W
    wotblake replied to the thread Freedom 235 Drain Plug Question.
    Thank you for Thank you for the response! I have no need to remove it right now. I just wasn't sure if there is any chance of it...
  • D
    DennisG01 replied to the thread Engine Flush Adapter no longer sold by Grady.
    While it can still be done, it's a lot harder to use the muffs if the boat is in the water. Secondly, using either the built-in hose...
  • W
    wspitler replied to the thread Floor drain hoses.
    Many posts on this. Port side may be doable with batteries removed, starboard side, nearly impossible without cutting. could remove the...
  • W
    wspitler replied to the thread Freedom 235 Drain Plug Question.
    It’s probably fine. That is a tapered, brass fitting (NPT). It will not completely seat, if it was me, I would remove it, clean the...
Show older items