DennisG01's latest activity
-
DDennisG01 replied to the thread 1999 272 Sailfish livewell drain.Yeah, since it's an actual livewell, you must be right. Obviously that fitting has been replaced. But it is strange - I mean...
-
DDennisG01 replied to the thread Transom Part 1995 272 sailfish.If not, then it was either pre-bent or just bent slightly over time.
-
DDennisG01 replied to the thread 1999 272 Sailfish livewell drain.Is it an actual livewell... or is it just a storage/fishbox? If the latter, it's just a normal drain. The notches are there to aid in...
-
DDennisG01 replied to the thread Swapping out F250 Yamaha for BT350 Honda.Granted, Honda isn't as "new" and advanced as the Merc, but... $25K difference?!?!!? Holy cow! That' s GIGANTIC difference and more...
-
DDennisG01 replied to the thread Transom Part 1995 272 sailfish.That isn't bad, at all. But, it's just a piece of "L-channel". You can get AL again, or get a piece of SS... but Al is just fine...
-
DDennisG01 replied to the thread Fender Locks.Yes - any reason you're not commenting on the recommendation given or answering the question asked?
-
DDennisG01 replied to the thread Failed through haul fitting?.The rust is more likely "crevice corrosion" due to the SS thru-hull (and tab) collecting water in the small crevice created between it...
-
DDennisG01 replied to the thread Failed through haul fitting?.There's no way to know anything definitively from that. It could just be tannins from the water that weren't cleaned off all the way as...
-
DDennisG01 replied to the thread Forward Bilge pump float question.See the part I wrote about the dash. That's how you can find the other ends of the wire - ohm them if you need to in order to confirm...
-
DDennisG01 replied to the thread Fender Locks.So "not" the Taylor Made ones? Which Taco locks are you referring to?
-
DDennisG01 replied to the thread Fender Locks.Tons out there - what style do you want? Post/link a few that you are thinking of and we can offer some thoughts. The Taylor made...
-
DDennisG01 replied to the thread 12v question.We use "X"Voltage to 12V stepdown converters all the time when rigging electric outboards on pontoons (they run 24V or 48V). So, sure...
-
DDennisG01 replied to the thread Scupper hoses.There's gotta be someone around with a trailer that you can borrow?
-
DDennisG01 replied to the thread Scupper hoses.I think you're fine to replace it in the water - just have a "worst case" back-up plan. For example, if your plug should fail... what...
-
DDennisG01 replied to the thread Forward Bilge pump float question."It clicks"... What clicks? Motor or float switch? Yes, you can short the float switch wires together to test wiring. Where does the...