Recent content by fishermanaddict

I am going to look at the boat this Friday, It is 1994 Grady White 228 Seafer with 2009 Etec 225 hp. with hard top. Is anyone know how this engine will perform on this boat? I would like to know Pro. and Cons. on this boat and engine. Thanks in advance

Re: Anyone in Florida own a GW209 want to give me a quick ri I had a1999 Escape I been 40 miles out of Southern California. I really like the soft ride and how the boat handle. The boat had trim tab and help alot.

I also have the same problem on my 1999 150hp Yamaha 2 stroke salt water serier II. Richie could you please also send me a manual too. Thanks

I also have the same problem on my 1999 150hp Yamaha 2 stroke salt water serier II. Richie could you please also send me a manual too. Thanks

Thanks all for your reply.

Thank you for the reply my question. What is the best way to resin the hole? Is there any tip to do it and where can I get the martirial?

I just want to seal for the water not going in the transom. I don't want to mount permanent.

Thanks for the input, I just bought boatlife in white color. The sealant I bought is removable not like 5200. Could I seal the decks and around the console with it?

Sorry for the confuse. I just raised my engine up 2 hole to get the right height, since my captiplate (spell) is too low. I want to reseal the mounting bolt for the motor to protect the water going in the transom. I was wonder what kind of marine sealant is Grady White dealer use when the rig...

Is anyone know , what kind of sealant should I used after relocated motor height for mounting bolt? What is the best way to apply sealant when pushing the bolt in?

Which mounting hole on your motor ? I also have 150hp on my 209 Escape . Motor was mount on 2nd hole from top , Got 5000 rpm max. So I raise the motor up by 2 hole rpm increase to 5250 rpm.

Striped Bass. I also have Yamaha 150hp 2 stroke. Where is the O2 sensor located on the motor?

Thanks Seasick, What is the maximum percent slip consider within the range for best performance?

I thought if I change to new prop the speed will reduce . I don't even know why at 4000 rpm I still get 30mph. Maybe some of the members on this site might know. I have noticed my hole shot and plane much quicker.

What RPM are you getting? I have 1999 209 Escape with 150hp Yamaha Saltwater Serie II . I was running Yamaha prop 17M 13.75 X 17 Pitch get 5000rpm at 4000rpm get 30mph 5000rpm get 40mph . I switch to Powertech 3 blade stainless. 14.25 X 15pitch increase to 5500rpm . at 4000rpm get 30mph...