Recent content by highfive28

I guess I should contact Grady re the bracket change? A single 300 would be around 24K and twin 150's would be 34K I would think. I should be able to get 6 to 8K for the HPDI's as they are solid. Not to concerned about docking as I have a huge slip and can get in and out without any issues at...

Thinking about re powering my 2001 232 twin 150 HPDI to a single 4 stroke 300HP. Wondering if anyone has done this or can it be done with the pod that I have now? The cost to re power with twins is out of my range. Also wondering what the used market is for 2001 150 HPDI's with 500 hours...

Have a 2001 - 232 and my AUX tank when selected goes to empty but the tank is half full. I assume the sender is done. Does anyone know a replacement part number or 3rd party replacement that is plug compatible. Thanks in advance ....

Have a 2001 232 with twin HPDI 150's and it's time to change the cables out. Wondering if anyone knows the length and or part number / supplier? I suppose I could contact GW but thought I would start here. thanks

Highfive28 Evan 2001 232 Twin 150 HPDI

Like the previous poster said - go on THT and search for "mystery filters". I just went thru this in the past 7 days with a 2001 150 HPDI and it turned out to be one of the filters in the HP pump. Yamaha says replace the $1300 pump - BS! Good stuff for sure and saved me lots!

Getting tired of dragging ice down everyday. Am looking into a 110 volt charging system. I run 2 x 27 Series batteries and can easily add another 1 or 2. I have 110 power at my slip as well. Just looking for advise if anyone has done this on a 232. thanks

No shore power - not needed as I am planning on a DC only fridge. When not used I will turn the fridge off.

Thinking about adding a fridge to my 232. Wondering if anyone has done it and where it was located ? Don't like warm beer!!

So after 6 or so hours of mucking around with the plumbing and wiring the new 12 volt toilet is installed and works GREAT! The old porta poti had a 1.5" hose out to the macerator and then a 1" hose out to the thru hull. I removed the 1" from the macerator and re routed it with a vented loop to...

I found the macerator today and it was under the tackle center under the companion chair. Looks like there is enough room to disconnect it and run new hosing for the toilet. Thanks for all the help.....

Well hopefully there is enough room under the seat to remove the macerator and run a new outlet line to the "Y" valve. Pretty tight everywhere under the hatches on this boat.

I too have the inspection plate under the stair tread and have looked. There is a "Y" valve and a thru hull with ball valve and I assume it is the live well inlet. Don't see the macerator there and that's why I'm asking. It has to be on the port side as I can hear it and it seems to be...

Great thanks for the quick response. I'll take a look there. Did you install a flush head?? If so what brand and did you install vented loops? I am looking at a Jabsco 12 Volt unit. thanks

I have a 2001 - 232 with a Sealand 960 Portable head plumbed in with deck pump out and macerator. I am trying to locate it as I want to replace it with a proper 12 volt flush toilet. I need to remove the inline macerator as the 12 volt toilet has one built in. Has anyone done this conversion...