Hookup1's latest activity
-
Hookup1 replied to the thread sealant for poly tanks - one last time.I would also use a Permatex fuel safe gasket maker on both sides of the gasket. Be careful you done strip out the screw holes... -
Hookup1 replied to the thread Original Panda 8kW witing harness..There are PVC pipe chases installed in the GW boats. Download your Owners Manual from GW to see approximately where they are located...
-
-
Hookup1 replied to the thread Gas tank lid delamination repair.You need to resize photos on my MAC PC. iPhone can resize them but you have to use the iPhone to post. How about a picture of this...
-
Hookup1 replied to the thread Gas tank lid delamination repair.I doubt it's just a small section that delaminated. Fiberglass will flex enough if there is something underneath it. Probably didn't...
-
-
Hookup1 replied to the thread Where is the Ground?.As Chris stated there is a good chance something is miswired. On my 1997 Islander all wiring was original, unhacked. What I hated most...
-
Hookup1 replied to the thread Where is the Ground?.Your going to have to live with the mystery...get over it. If it bother you that much re-run the wires - mystery solved.
-
Hookup1 replied to the thread New Facebook Group - non AI.Don't waste your time. All the Facebook jabber is real lightweight and not very interesting. Lots of silly repair or general questions...
-
Hookup1 replied to the thread Livewell pump runs but it won't fill.Where is the OP CanadaJoe? What's going on?
-
Hookup1 replied to the thread Gas tank lid delamination repair.As SkunkBoat said - repair from the bottom. Take it all out, use a composit and epoxy to repair and be done with it. Done right done once.
-
-
Hookup1 replied to the thread Options to Protect Teak/Holly Floor.I'm assuming you are talking about the interior. I don't understand why you would want to cover up a good looking floor. The F&S...
-
Hookup1 replied to the thread head odor and potential mod.The problem with these heads is using salt water for flushing. It seems to interact with the waste in the tank and sours. Fresh water...
-
Hookup1 replied to the thread Where is the Ground?.On my boat they are direct to the battery. Positive sides are fused. Get back there and follow the wires. Take the miscellaneous black...
-
-
Hookup1 replied to the thread Where is the Ground?.Download the GW Owners Manual from GW site. Look at the wiring diagram. Will show how bilge pumps are wired and fused.
-
Hookup1 replied to the thread Livewell pump runs but it won't fill.Photo of the pump please... Putting a hose in it doesn't prove anything except the hose works. If you are telling us that water will...
-
Hookup1 replied to the thread Livewell pump runs but it won't fill.If the above two checks are ok pull the pump. It's probably a Rule pump that twists and pulls off. I have impellers break off the shaft...
