Recent content by mikesne

The rule is the boat is to be registered in the state where it is primarily used, doesn't matter where you reside. I registered my previous boat in DE, the new one in PA. I trailer it to MD, VA, DE, OH and PA. (haven't paid the tolls yet to cross the bridges into NJ just yet) I'd worry more...

I did my transom on my 82 Overnighter about 3 years ago. Cut the outer skin, removed the rotten plywood, and replaced with 2 layers of new Okuma 11 plywood, then glassed a new outer skin with epoxy and 7 layers of 1708. If I had to do it over again, I would take off the rubrail, cut the cap...

Do you have any pictures?

Any pictures?

the 175 had a 17p, I could only get about 5200 rpm’s at WOT. the fist prop I had on was a 19p and I couldn’t get to 5000 all the way trimmed up. I really think that I had something going on with the motor. I now moved to a 200 4 stroke Suzuki. The dealer is installing a 21p. I know the gear...

I haven’t got it back yet. The first 10 yours is break in time and I can’t go to WOT until there’s about 5 hours on it. I’m just trying to save them the hassle and cost of changing out the prop if they get it wrong.

Hi, I have a 204c that is at the dealer getting a new 200 Suzuki. The dealer messaged me earlier and said they were going to use a stainless 15.25x21 pitch. My (inexperienced) thoughts are that a 19P would be more accurate. the old motor was a 175 2 Smoke with a 17P. I never could get the right...

Thanks

HI, can anyone tell me what the hole size is for Suzuki 5" tach and 2" fuel gauges? I'm making a new dash panel for a new outboard and can't find the specs on Suzuki's site. Thanks

Trolling motor install 1

trolling motor install 2

Trolling motor install 3

I'm currently installing a Minn Kota 36V on my 204C. After a ton of research, I decided to go with 3- 100ah lithium batteries. I'm also going to install a NOCO on board charger.

Feels Reel is showing the correct spot. In the 6" access hole. It's just about impossible to reach. I have my batteries on each side of the stern underneath the seats (if they are there) You can try to reach it from there as well. I put a new one in last year and have an issue with it, so here...

Or use an ACR and not need to worry about switching by hand.