Recent content by Scarlett->Fire

Good call, I could remove the cap and measure the other side. Thx Dennis

Greetings - Unfortunately, I am having to replace the starboard windshield 1/2 on my 2004 300 Marlin. - Very long story but I've created a mold to get the bend right and my thickness options for polycarbonate or acrylic are 1/4" or 3/8" thick. I cleaned up the shattered glass so well, I don't...

Will do, thank you

YES! Unfortunately, it is not being made anymore. Custom glass out of Florida at around $5,000. ANYON̈E PARTING OUT A 300 MARLIN??? If I can't find one, I'll likely have it made in acryĺlc with scratch resistant/ densifyer coating.

Greetings - wondering if there is a 300 Marlin windshield out there for me to purchase??? Pre- 2006

Thanks for reaching out / I don't check the site all that often. Do they come with bases? And how much $ ?

Thanks for this Harry's, I relied I hadn't sent a reply / very helpful when I was planning ! I'm almost done and will put some pics up and a few notes in a new thread when completed. THANKS again!

I will likely have to explore alternative material / sooo excited about fishing my new boat and here I am, so frustrating...

Good Idea on the other website checks / just started researching, so much to learn I'm sure.

That's what I was afraid of. It is the curved piece.

I had a VERY bad day today, with the result of an embarrassing story being that I shattered the starboard side of my front glass on my 2004 300 Marlin. Can replacement glass be found? Yes, it is the large curved piece. I have been sick to my stomach since I heard it shatter beneath me...

I wasn't going to start on anything until I have the boat, just looking for rough measurements to see if my configuration even has a chance of fitting. I guess noone can get me those #'s.......

Good point as well to think about. This is really a great site, and as a Grady Newbie I'm so thankful for the wealth of knowledge. I can hopefully be a valuable contributor down the road as well!

Very Nice, definitely what I'm going for - it looks great, thanks for the pic. As discussed, I'll do my own measurements for the project, but do you know roughly what the width of the panel is at the bottom, at the top, & then the height in inches? Just trying to see if my configuration is even...