2004 300 Marlin "console"

[Harrysea]

I've purchased a 2004 300 Marlin but it is still located 150 miles from me and I'd like to do some planning for electronics. I've seen some great flush mount installs using star board or a flat panel of the
graphite.lookingView attachment 36666
material face. My question is this. If I cut out the corners and put this new panel on... what are the dimensions of it? Obviously it tapers thinner towards the top -
what is the (Width at the bottom ", width at the top " & heighth " ) ?

Thanks in advance
SCARLET >FIRE

Top of console: 25”
Bottom: 33.5”
Sides: 13”
Height: 12”

I hope this helps. Plenty of room for two MFDs or one of a larger size. I don’t believe you could mount two MFDs larger than 12”.

 

[Scarlett->Fire]

Top of console: 25”
Bottom: 33.5”
Sides: 13”
Height: 12”

I hope this helps. Plenty of room for two MFDs or one of a larger size. I don’t believe you could mount two MFDs larger than 12”.

Thanks for this Harry's, I relied I hadn't sent a reply / very helpful when I was planning ! I'm almost done and will put some pics up and a few notes in a new thread when completed. THANKS again!

 

[SeanC]

This can be a fun project - but I don't think it's something you want to try and create before having the existing panel in your hand. Nothing against any of the guys here, but to make this look GOOD, your dimensions need to pretty much dead-on and you don't want to rely on some guy's dimensions on a forum

New Wire, as noted, may be the easiest solution. If they don't have your setup, mail your panel to them once you get it.

What do you mean? It's 2.5 bananas wide an 1.63 bananas high. That all the info needed.