Sdfish's latest activity

  • S
    Sdfish reacted to Peter A's post in the thread another Prop help thread with Like Like.
    Thinking you will gain 200-300 rpm just by trimming out. Do you have a hardtop, were you running with canvas, were you running with a...
  • S
    Sdfish reacted to DennisG01's post in the thread another Prop help thread with Like Like.
    Hmmmm.... others with that boat can speak more intelligently than me (well, many, MANY people can!). But you're running a 15" pitch and...
  • S
    Sdfish reacted to Ekea's post in the thread another Prop help thread with Like Like.
    best advice i can give is to call ken at prop gods. beyond that, id call grady and see what they put on the boat with that motor. im...
  • S
    Sdfish reacted to DennisG01's post in the thread another Prop help thread with Like Like.
    That sounds like a good plan - and that load is a good load to test with it (not "overloaded"). I suspect you're going to see those...
  • S
    Sdfish reacted to Mustang65fbk's post in the thread another Prop help thread with Like Like.
    Attached below is the Grady White performance bulletin for a 208 Adventure with a single F150, in which they used a "14 1/2 X 15...
  • S
    Sdfish replied to the thread another Prop help thread.
    I should note, that the current prop was from my previous 2 stroke motor. My dealer recommended a new prop and will suggest one, but i...
  • S
    Sdfish replied to the thread another Prop help thread.
    Hi Dennis - compression and engine are fine, low hours and runs great. just took a look at the picture I took and I did NOT have the...
  • S
    Sdfish posted the thread another Prop help thread in General Discussion.
    Hi all, I have a GW Adventure 208 with a Yamaha F150 on it. Current prop is a 3 blade stainless steel 15 1/4 X 15, max RPM at full...
  • S
    Sdfish reacted to Hookup1's post in the thread Starter help!! with Like Like.
    Check kill switch lanyard clipped in. Make sure shift is in neutral. Clip volt meter to ground and small lug on engine starter...
  • S
    Sdfish replied to the thread Finally closed the deal!.
    Beautiful boat!
  • S
    Sdfish reacted to GH02050's post in the thread Finally closed the deal! with Like Like.
    I was poking around this board last year trying to lean what I could about the Gulfstream 232. At that time I was trying to buy a 2010...
  • S
    Sdfish replied to the thread Bilge Pumps.
    Seasick - 100% agree! I have 2 bilge pumps and a highwater alarm. 2nd pump is located a few inches higher in my bilge. I also have...
  • S
    Sdfish replied to the thread Bilge Pumps.
    Not overkill in my opinion!
  • S
    Sdfish reacted to Thor's Outlaw's post in the thread Bilge Pumps with Like Like.
    Great Advice! I just installed a 2nd bilge pump in the stern of my 228- Overkill? Maybe, but I have piece of mind if one suddenly fails.
  • S
    Sdfish replied to the thread Bilge Pumps.
    Great reminder! I keep my boat on a trailer, but that is a MUST pre launch checklist item for me.
Show older items