Recent content by SeaSaw

I am interested in this pair for my 366 but the varing dead rise angle appears to be greater than 20 degrees, where on the hull is less than 20 degrees deadrise?? Thanks

Thanks I did speak with GW when I did the tour and that's the approximate location they gave me as well. My concern was that the Airmar instructions indicate mounting the ducer "to the side" of the motors. But I suppose motor interference isn't a concern that far up the hull.

:hmm Any suggestions on where in the hull to install a B260 Airmar/Simrad transducer on my 366 Canyon with 3 x 300? I will be installing the Simrad NSE 12 system and the boat will be held on a lift so the bunks are a concern.

Thank you for all of the insight and help! I just completed my GW factory tour and it was a great experince. I asked Dave the senior GW engineer since 1976 about weight loads and there is no issue with mounting a 6' open array on thier boats. I questioned him again about the unit I am leaning...

Looking for tips and advice on radar. Should I go open or dome on my 366 which is on order? The range is dependent on height above water so I don't see what advantage an open radar would have on a hard top mounted CC. Does the power make a difference on resolution? And is HD much better? Thank...

I'll be good with mid to high 40's considering the beam of 13.5'. But maybe I'll do better on the CC since these motors will be almost 800 lbs lighter than the 350's. I'm coming from a 38 Rampage with 2 x C9 so this will seem like a Cigarette!

Those are amazing pictures! Thank you for posting.

Please do post more info and pics. I am thinking I will need some type of sun shade bimini for my CC. Thank you.

Hello all new member here. I have placed an order for a new 366 Canyon 3 x 300 to be delivered in early spring in Brick, NJ. Any tips on electronics or otherwise would be greatly appreciated. I am looking at Raymarine E120W and was wondering what the more expensive 400 model sounder does for...