Recent content by TenKutas

Finally getting close !!! Running wire and plumbing hopefully splashing this Sunday!!!! :dance [/attachment]

Mounting height ??? 1” higher for every 1’ if set back. Anyone have a similar setup? What hole/height are your motors??

That’s exactly what I’m thinking Skunk Boat !! Waterman industry’s pot/line hauler mounted thru the shower/head area. With blocks along the walk around to pull the lines from the rear. Wreck fishing in the fall and winter calls for more than just one hook in the earth. The have setups on...

I’ve seen quite a few sets on EBay lately coming out of Florida, Jersey and Connecticut. I sent the seller a message to make a deal. I’d call around to dealers local to you. Tons of low hour motors coming up on the end of their warranty’s to be had. Get the Serial Numbers for a warranty check...

I’m going with new to me. 2012 ,250’s with 800 hrs. They should be here Friday ! I’m getting all my ducks in a row. It’s going to be great having adequate power. There’s a set of 200 H.O. and 250’s out there with low hours for good prices. I worked out a package deal for everything don to the...

I’m getting started on my dual anchor pulpit/line winder design/install. Anyone in the community have photos or good links that I can get ideas from ??? I’ve seen some “trick” set ups on charters I’ve been on.

The holes on bracket are 28 1/2” centers.

Those 17’s are great for the Holeshot and heavy loads ,19’s will get a little more top end. I think you should be seeing more like 1.5-2 out of your rig. Have you tried raising your motors one hole at a time .... They on a bracket or transom ?

Help and suggestions are greatly appreciated. Repowering with Gen 1 250 ETechs. I have a glassed in transom with bracket. 1) What should my centerlines be when rigging these twins ? I’ve been reading other posts but haven’t found the answer. Hanging the ETechs this Friday into the...