Search results

I used interlux micron csc but there is epoxy under it. I have not heard of that before, hope its not a problem. I did my old 19 mako with just bottom paint back in the day and I think I did my 87 22 seafarer with just paint. perhaps they became someones elves problem down the road. i hope not...

After waiting most of the day for the tide to come in so we could launch we finally got her into her slip. we also got 15 plus winds so that was a fun way to get aquatinted with the new neighbors. but we did get out for a shake down trip. big take away from trip is I need help with a prop...

today is the day. dropping her in on the afternoons high tide, IM READY! 5 weeks of crummy weather for working on the boat. Yesterday found the bilge float wire was bad, the last thing I had to do was fill it up at home so i don't sink in the slip and it failed. will pick p new wires and rewire...

Interlux 2000e epoxy primer went on today, 2 coats. Next will be Micron CSC coats. The bottom paint will need 36 hours or so between coats. The stripers will be gone before we are in, good thing they come back! Apparently the boat had been bottom painted previously then stripped and re gel...

I got the combing bolsters in, electronics done for now, nav lights and cockpit lights done, stereo done, interior cleaned up and keel damage repaired. It's time for the bottom, I'm getting closer to being on the water.

Right now the side compartment the same as when it was new except that everything has been replaced with the plastic. Eventually both port and starboard side will be made into neat storage for drinks, sunglasses, lure hanger, sun screen. I've run out of plastic for now so those things will wait.

Yeah I have been busting my butt to get her done. the weather has not been good. I managed to get the port side 85% buffed out today, the starboard side is done but could use a going over up front a bit. I also got the fiberglass work done on the keel up front where they kept bashing the cross...

yes that is one piece. I think there may be a second piece that connects to that rod and then to lever. I found 2 pcs laying in cabin when we picked up the boat.

Can someone tell me where I can get the parts to replace the extension arm on the seacock valve up to its mounting location under portside seat. Also the original handle is broken off for the bait well/wash down selector, can I find this somewhere? thanks in advance for any help.