Search results

I think the cooler water pump has to be on for the heater to work -- just like in cooling mode.

We took a serious bump on the port rubrail about 15 feet from the bow a few months ago and other than a dent in the rubrail did not think much of it. Last weekend got into 10 foot seas and was taking water over the bow for a few minutes. Water was coming into the cabin on the port side from...

Perfect place for it but it's not there. I will have to ask the first owner. Thx

Is there a separate cushion somewhere that covers the table top of the settee on a 360 when the table is lowered to make a berth? Or do the back cushions - which look curved -- flex into a straight shape and fill in that space?

I had checked the vent and it was open. The screen was already removed or broken through because I pushed a flexible tie wrap in one end and pulled it out the other end. I would post photos of the project but I cannot figure out how. I checked the FAQs but did not see any references to photos.

I want to add closure to this holding tank issue with help from the Sealand folks and their rep at AER Supply in Seabrook TX. The issue turned out to be a combination of stuck sensors on the tank level indicator so that the tank was near full or full when it only read low or mid full and the...

Yes, it was properly installed. The grommet fits in the tank hole and the valve fits in the grommet. They were both seated properly. Tight fit too, but there is nothing but friction holding both in. The grommet stayed in the hole both times and the valve popped out. I think I actually heard it...

The Sealand black water holding tank on our 360 has blown out its tanksaver valve while offshore in the GOM twice in the past month. The valve is the device set in the top-rear of the holding tank that is supposed to vent air into the tank during vacuum pump outs to protect the tank from...

yes, the boat is new to us and the previous owner changed impellers every year at the beginning of the season too, and had no other problems. We are hauling the boat for 400 hour yami work today and will replace the kinked Panda raw water intake hose and see what happens. We are careful to...

Thanks, I thought the scoop idea was nutty. The seacock and strainer are very close so the hose is only about 10 inches long. I could put a little loop in a slightly longer hose or put a 90 on the seacock to get them to line up in the same plane. The genie is a factory install by...

Our 8kw genie with 600 hours has burned up three raw water impellers in the past two weeks on a 2007 GW360. It runs fine in the slip for hours with normal temps but after less than an hour or so on plane the genie shuts down and displays hi temps at cyl head and fresh cooling water in. It is not...

I just bought a 2007 GW 360 and the maintenance log shows genset oil changes every 100 hours or so for the first 500 hours. The Panda manual says change oil at first 35-50 hours and afterwards the oil is to be changed after 100 hours. But later in the manual there is an oil change schedule...