Search results

  1. G

    ox66 trouble shooting

    I did replace the O2 sensor off a extra motor I bought for parts Thew I never tested it. The sensor was very clean. I will have them tested. I was thinking off replacing the injectors this winter as well. Not related to this issue but just as a safe guard do to the age.
  2. G

    ox66 trouble shooting

    I believe it idles 5-6. Replaced the low pressure pumps in July. Thanks for your help
  3. G

    ox66 trouble shooting

    They starboard motor has always back fired with in five seconds of running at idle. Sometimes stalling the motor. Once in gear they run smoothly. (given alittle throttle) Thinking it could be sucking air. O2 sensor is clean, good plugs, new low pressure pumps. The starboard motor has 1300 hrs...
  4. G

    ox66 trouble shooting

    Thanks for your help. By Spitting it is the back fire they seem to do. I shall mess with it next time I am at the boat. I hopefully am going to take her out Thanksgiving week weather permiting (Tuna/Wahoo). Then home she goes for a overhaul. I am going to redo interior, repaint motors, Wax ect...
  5. G

    ox66 trouble shooting

    One of the fuel tanks was running low so I switched it over to the main tank. Both motors ran fine for a hour or so than starboard motor ran out of fuel. I switched it back to aux, ran fine the rest of the day. The main tank was full. This was two weeks ago. Took it out today same issue. All the...
  6. G

    232 transducer issue

    Had a gulfstream same problem so i put a threw hull in. Worked great
  7. G

    My New-To-Me 272

    Congrats, winter will be here and gone before you know it. Beautiful boat
  8. G

    248 Voyager - Docking

    Our slip is in a good current. This is how I dock it in the wind. Did it on one motor with the marlin. 1. start turning the bow two slips before hand. 2. With boat drifting vertical to slip keep the stern as close to docks as possible. 3. When you feel the moment is right...
  9. G

    marlin or sailfish for extended stays?

    We stay on our 91 Marlin like it just fine. We also have a Sea Ray 340 cabin cruiser. The Marlin is our primary fishing boat. For our family of five ,our three daughters use the Marlin and the captain and I stay on the Sea Ray. Sometimes the wife and I will take the marlin to Cape Lookout the...
  10. G

    1990 Marlin with Suzuki DF250s

    I have a 1991 marlin with Ox66 250s it seems to get 1mpg ,older motors less fuel efficient. It is a big heavy boat that rides like a dream so if it is not a hybrid so be it. My trim tabs are not working either. Seas are 2-4 on the eights. Suzukid250s are great motors an extra .5 mpg would make a...
  11. G

    225 overheating

    I would give it a try. It might come off easier than you think. If it is struck I would take it to a pro. Can not hurt to try.
  12. G

    225 overheating

    When was the water pump changed?? Have you keep up with the maintenance? Thermostats ??
  13. G

    ox66 shifting Rough

    Thanks, Will give it a try before replacing them.
  14. G

    2000 Marlin 300 re-power

    Hey I need to replace my motors would you sell them outright???
  15. G

    ox66 shifting Rough

    When I put one of the motors in gear it shifts hard. Like the prop is seizing up. It sounds and feels like it is dragging on bottom(8 feet of water). Pull it in and out of gear acouple of times and it is fine. Wondering if it is on its way out. I did change the gear case fluid last week. One had...
  16. G

    250 OX-66 Thermostats?

    If it is not overheating check the oil res. sensor on the motor. They go bad and are frequently the cause of the alarm
  17. G

    Help with 91' Sailfish 252G / SV2 Hull ?

    Had a 93 gulfstream same as a sailfish just two feet shorter. It was a badass fishing boat ran many 100 mile fishing trips. Alot easier to handle than my current boat.(docking in a current or wind) I enjoyed the boat a lot. Just be prepared for heavier fuel bills
  18. G

    Trim Tab is gone

    No damage just gone. Weird yes. Not worried about it dislodging I believe it has been gone for a while. Sense May anyhow. One less issue to trouble shoot.
  19. G

    Trim Tab is gone

    Pulled the boat saturday to replace trim motor and noticed the trim plate was gone the hydraulic cylinder is still there thew. I see no harm in using it like it is until I get a replacement? If the hydraulic cylinder was to depart what damage could it do?? Flat seas saturday in the Carolinas...
  20. G

    1990 Marlin Complete Rehab Complete

    Great boat enjoy her.