Search results

  1. DaveG

    Flushing Engine Water Flow issue

    appreciate truly and hope it goes as planned
  2. DaveG

    Flushing Engine Water Flow issue

    Thanks. appreciate the fast reply. I will give it a whirl and maybe Y connect so it fets a good prime.
  3. DaveG

    Flushing Engine Water Flow issue

    Good Day. Have a question. I have a 2021 257 Fisherman with twin XB150 outboards. I have been trying to figure out when needed to run engines on dry land I am hooking up my ear muffs and not getting any flow through all my cooling outlets before cranking engine. I have good flow in water and...
  4. DaveG

    Access to Garmin 8616 SD CARD on my Fishermen 257 F

    Yes. It seems to avoid any Garmin updates for firmware specific. I actually called Garmin and they sent me a free reader for unit. try that first calling support and state your case. They will send you a reader kit on house. I just accessed from inside head area and be careful pulling if you...
  5. DaveG

    Access to Garmin 8616 SD CARD on my Fishermen 257 F

    I cannot not access anything from front. it is hard mounted to console. only access is from inside
  6. DaveG

    Access to Garmin 8616 SD CARD on my Fishermen 257 F

    Question. My Garmin 8616 GPS sonar was installed at the dealer and I need to access the SD Card Slot which I can only access through the battery compartment. Is there any information out there in how to. I know that the battery panel comes out but there is a wire harness terminal above it but...
  7. DaveG

    HELP WITH Grady 257 2021 Fisherman Fresh Water Leak Found When Servicing

    Hello All Not sure if any one can help but here it goes: Went to top off my fresh water this morning on my new 2021 Fisherman and seemed that water running very slow out of nozzle. I went to service the fresh water located toward the forward seat bulkhead left and ran water till coming out of...
  8. DaveG

    Fisherman 257 Bungee Type Cover for aft swing down seat question

    Hello, Does anyone know if there is any after market canvas or water proof type bungee covers for my aft swing down seat in the back. Mostly for protection when docked. I just need something basic to cover without using snaps. Thanks for all that might know. I have looked everywhere
  9. DaveG

    Lowrance LMS332C in dash Replacement needed Advice

    Understand. Many Thanks!
  10. DaveG

    Lowrance LMS332C in dash Replacement needed Advice

    Thanks for the response. I will certainly look at what options are. I also have to keep in mind I have the GPS ANTENNA mounted near the fuel access cover and would also need to have that replaced. Clearly I am sure the new units are close to the same size but don’t want to start new cuts all...
  11. DaveG

    Lowrance LMS332C in dash Replacement needed Advice

    Hello, I have a Grady 2006 205 Tournament and need to finally replace my Lowrance LMS 332C GPS/SONAR Unit after 12 years. I am looking to avoid re-wiring or having to pay someone to do it. It is a very cumbersome job but think I might need a pro. Does anyone have any suggestions other than...
  12. DaveG

    Lower Unit Oil coming out of prop when servicing

    Yes, I put the top screw in as I was getting almost full which seem to cause a little pressure in turn oil coming out. Should I have a pro look at it? Thanks for the Reply!!!
  13. DaveG

    Lower Unit Oil coming out of prop when servicing

    Any Help Appreciated! I was servicing my 150 4 Stroke Yamaha with proper fluids and as I topped it off I noticed fluid coming out behind the prop. Put a little too much in. I immediately stopped and screwed the service plug back in and ran the engine with the ear muffs on. I just had the water...
  14. DaveG

    Electrical Connectors for Washdown Pump

    Thanks a bunch. You certainly have it all detailed. I have some experience with aircraft type cannon plugs and should be able to replace. They certainly do not make it easy at the local level to get things as close to oem. Thanks again!
  15. DaveG

    Electrical Connectors for Washdown Pump

    Hello Does anyone have some advice as to where I can find replacement connectors that are used to connect my "Wash-down ShurFlo Pump”? The connectors that are on board are original from factory (2 PIN) and not sure if they can break apart to be reused and did not want to take a chance and did...
  16. DaveG

    Engine Decal Needed. Any Advice?

    Hello Looking for a new Sticker to replace my Yamaha F150 Outboard Four Stroke Sticker. Just the one and not the whole se. Anny ideas. 2006 Model
  17. DaveG

    NEED HELP WITH RUSTY BUTTON STUD SNAPS ON FIBERGLASS

    Rust issue The dealer ran over all the metals on boat going as far as the railings bow side and treating root of where rod ends go into fiberglass. Rust was leaking or should I say bleeding color. They cleaned and sealed areas all over including the button snaps and replaced ladder and treated...