Search results

I like that filter but I barely have enough room to put my hand under it to unscrew if off as it is

I.like that idea of using both tanks. Keeps the fuel fresh

Ya the boat yard suggested a plate in the step but I would hate to drill a hole in the middle of the step. I siphoned out 2 gallons yesterday out of the main line but that pick up tube dosen't hit the bottom so I can't get all that water out. This pic is the contents of 2 filters and me pumping...

As stated, 2001 268 islander. Water in reserve tank, trying to pull sending unit to get to gas but it hits the step. And ideas would be great

Thanks guys

2001 268 Islander, my trim tabs work up and down, but go extremely slow, like 30 to 40 seconds to go out and In. They also dont seem to extend very far, maybe 2 inches is this common? I just topped fluid and used my foot to try and extend further but they won't go further and the motor stops at...

Yes both taps are up, motors counter rotate

So my boat sits level in the water, trolls level at low speeds. But at higher rpms, she lists to port with even weight in the boat. I have trim taps but figured she should ride level if the boat is even weight. Any ideas as to why ? She has twin yamis 200, hpdi

Glad to help

He has my parts, I would assume you only need to give him your height and the diameter of your pin on your table. Im having him make my post at 24", I'm not sure if our boats have different seat heights. Good luck

I talked to Bob from Merchant Marine. He said he would make one for you, they will only be in the shop on Wednesday. I didnt ask him the cost. Here's his info.

I just noticed, you can see the bottom of my table in the pic above

The bottom of your table is different than mine. Couple questions for you, do you have that little piece they are using as a stopper in the pic above. It's under the dove tailed aluminum peice? Also I would need to know the dimensions width and depth of that spindle on the. Bottom of the table...

Can you send pictures

I am sure he would as he owns the machine shop. You could probably purchase it through his shop. The crucial part is that piece that goes into the table. I have mine and he is machining that to go into the post. Now That I'm thinking of it. He could probably machine the end to go into your...

do you have the part that connects to the table? Its black plastic. I dont have a picture of it right now its at the shop

Yes, there are groves the pole slides into. I called a machinist friend who is going to make something

No success

I found a video of a grady for sale and took this pic of the post we are looking for. If someone comes across it. This was on a 2001 sailfish, I have the 2001 islander. Thanks