Search results

Here’s a video of how it’s supposed to work: Looks like brute force wins the day…again!

I’d be inclined to address every hose and filter having to do with fuel, including the tank, if it hasn’t already been replaced.

Marine 31, then protect with 303.

My guess is the engine and prop are performing correctly. Another guess is the boat has a decent hole shot which I considered more important than wot. Since you’re close to 50 anyway, pick a day during a king tide, mid-tide, run with it for your high speed run. Or, change prop pitch for more...

That door is a molded plastic and solid color through. Suppose you could paint it, but would likely require a lot of prep to make sure you get adhesion.

If you have a rod holder near the ladder there are hand rails that fit in a rod holder. Also, if you don’t have access to tighten a nut a surface mount rail may be stout enough.

Anywhere to add another hand rail to help?

Hull fouled?

If your 215 has a Bimini top that comes with a dodger from the windshield to the Bimini and side curtains. I believe the rear curtain is available as an option which would fully enclose the cockpit. If you put up the companionway curtain that seals from the bottom of the windshield to the floor...

This is on a 215. Marinco plug for your extension cord. The dual battery charger is on the other side of that bulkhead. I put in a NOCO 2X5 amp. Had to extend the chargers leads for the port battery On mine, there was some plywood glassed in on the back side of that bulkhead so you had something...

Looks like over tightened fasteners. Repair is usually to route layer of gel coat off and then fill. Non-structural.

If you have a t-top, LaPortes makes a cover called a “console cover”. I bought one for a small Pioneer I had a few years ago. Basically they’re like a shower curtain that hangs from the outer tubing of your top. Doesn’t cover the entire boat obviously, but covered the console, electronics, etc...

I used Caj Flynn years ago to move a smaller Grady from Pompano Beach to Charleston. Did an excellent job at a fair price. All “blowables” were stowed and hatches taped down. Previous owner didn’t have a trailer so they used theirs. I don’t know if he’s still in the business as it was many years...

Perhaps there’s room to move it up a few inches, then patch the old hole. Newer throttle for electronic engines is shorter than what you have and isn’t compatible with your engine anyway. Couldn’t tell from your pic what type of helm seat you have, but if it has a movable bolster put that up as...

Here’s their service directory https://www.fischerpanda.de/en/service/global-service-directory

If your buddy has a 27’, you need a 285 or 307.

Congrats! Thats nice.

Greetings and welcome! That’s a beautiful part of the country. Idaho was part of my territory when I was based in Phoenix. Most of the industry was down near Boise/Nampa so I’d fly in there and fly out of SeaTac. Usually the last night of the trip would be in Coeur de Alene. I had a customer in...

Normal for it to blink when the motor raised. Sounds like the trim sender lever is stuck.

My local dealer, Seel’s uses “Almond” tinted silicone. Matches the factory color well.