Search results

I need that, if no one else has already asked. I will PM you the same.

If you are not sure whether they are 15° or 30°, lay three of them on a table top. Put the flange of the first one parallel to the edge of the table, and the flange of the next two perpendicular to the end of the preceding tube. You will end up with either a 45° angle from the table edge, or a...

I had pop outs in the splash well of my 93 tournament. In the automotive world, such stupidity would probably result in a factory recall, and a dealer replacement with screw ins. I drilled a small hole through the reinforcing rib on the bottom of the plate, and secured each one to something...

Is your trickle charger constant voltage, or is it a smart charger, which turns itself off when the battery is topped off?

"With light fuel and crew, you can hit 50MPH is relatively flat conditions with a burn of 1.0 -1.21 GPH as I recall........" If I were getting 40-50 MPG, I would be happy as a clam.

The V6 just came out this year, didn’t it? The link you were reading may have applied to the V8’s.

OEM part is probably half, but at $125/hr labor, it is not a 6.8 hour job. Post a copy of the invoice, if you go ahead with it.

V8, or the new V6? Talk to your insurance company, and get it in writing that your coverage will not be affected. Yamaha did not introduce a 350 until 2007, but your boat probably had max horsepower for the time. If weight and performance are not dramatically increased, they should give you the...

I think 14G is wire size.

What size are the tabs, and where are they mounted? Sometimes I see them way in board, right next to the motors, and I just don’t understand it.

If the bulb collapses, loosen the gas cap to see if the vent might be clogged.

Don't let anyone talk you into an over-the-hatch model. A portable will work, but they take up a lot of room. You could have it on deck, and vent into the cabin, but you lose the benefit of dehumidification that way. Most efficient is cooling inside, exhausting to the outside.

Craigslist, Marketplace?

If they have not started since the winter lay up, I would bet that a cable/wire was not re-connected when the batteries were installed. When I take a battery out, I put a small wire tie through the eyes of everything on each terminal.

SIM is Ship Island Marine. An excellent source for accurate information, and OEM parts. Google it, or look for their banner on the website here, which is currently at the bottom of the page on my phone.

Who are you ordering from? I would think that the manufacturer would only need your boat model, with or without pulpit, engine bracket, etc. Look at the big guys, like Carver, and see what they spec for your boat.

If the float switch in the main tank (engine mounted) is properly adjusted, the oil level shouldn’t be near the top of the tank. With the cowling off, you could draw that tank down below the “Minimum” line, and let it run through a refill cycle, to see if it is overfilling.

I would have guessed that the gauge cluster is older than 1994. What brand of motor came on the boat?

Can you not see them inside the hull? Have the hoses, or floor drains ever been replaced?

Pretty pictures, no prices, I think MH is aimed at boat builders, not boat owners.