Search results

Actually the 50/50 Trans/Acrtone works very well..... shake before using .... And does even better with heat than commercial oils

Seams like you have to register an account and order in volume to buy

Go online and pull up the owners manual for your year and model. You will see a schematic of all the rigging tubes that are built into the hull.

Grady didn't do us any favors with the way they routed and installed the helm wired remote....

tony 201

I LIKE THE IDEA OF THE GENERATOR BUILT IN .. i DON'T LIKE THE iDEA OF LASHING IT TO THE DECK ..... I WAS WONDERING IF ANYONE WAS ABLE TO SAFELY INSTALL A SIMPLE AND RELIABLE HONDA TYPE GENERATOR ... THAT'S ALL I WAS ASKING

So my "07 Marlin has a Fisher Panda .... I don't use it much , but every now and then I start it up and put a load on it ... if I am out and want a cup of coffee there isn't and alternative, because Grady installed an electric stove top .. .... It comes in handy during stripper season for...

Twin Yamaha outboards each with a starting battery and 2 house batteries ..... How is yours wired ? did anyone modify the oem Grady wiring or installation ??

When as the 272 Sailfish designated as a 282 ?? was there a difference in the hull ?? I assume that change also pushed the 28 Marlin to the Marlin300 ?????

Ditto !!!!! I am also looking to replace the port helm seat with a companion seat .....

Well after 3 attempts ( 2 to Tech support and one to customer service) to communicate with Grady about this, I have had no reply .... a little disappointing !! So much for Grady's Highly rated customer service .. On another note: I looked for wires at or near the diesel tank ... I wasn't...

I have been using a momentary on-off -on toggle switch for about 2 years ....I gutted the original switch out of it's framework and installed the basic toggle with a rubber boot .... Just couldn't justify the cost of the OEM...

Hi Dhrish ..... did you install or factory ?? do you have a picture of the gauge ?? thanks

No response from Grady yet..... I have sent again

I put a request for information in to Grady ..... let's see if they respond .... I will have to look again to see if the wires for remote gauge sender wires are near the tank ..... If they are , I wonder Where they are for the gauge ???????? I saw a picture of the Generator control panel...

I just happened to be looking at Generators recently .... the Northern lights 5kw caught my eye for at least further investigation. My FP only has 28 hours on it ... I did need to do some repairs on it when I bought the boat ... The price and availability of parts just rubbed me the wrong way...

So my 2007 Marlin owners manual shows a Generator Fuel gauge installed in the cabin ...HOWEVER !! The only gauge is a mechanical gauge mounted on the Diesel tank... I would like to mount an electrical diesel fuel gauge in the cabin or somewhere visible. Wouldn't it be nice if the wiring was...

There are a lot of thoughts on this thread, with some installations more permanent than temporary or portable ... A lot of good thoughts .. .. I would appreciate knowing what you decide on....

I painted mine ... they came out pretty good and are lasting

Comment on the Electric windshield defroster >>>> 1500 Watts will give you about 5200 BTUs.... Watts = volts multiplied by Amps>>>> So a 12 volt DC windshield defroster that draws 20 Amps will give you 240 watts.... about 820 BTU's .... Not a whole lot of heat