Search results

I saw where someone cut access in the deck just outside the tuna door and installed a plate ( that wouldn't be my first choice)

Good luck with your project. I know I'll be looking at going down this road someday too. Does anyone know if the Scientist at GW are going to change over to encapsulating this edge in glass or they still going with the plastic cap ??

I think when the time comes to do mine I will have it fully glassed over and documented with pictures ... then have the vinyl cap glued on so the next guy who buys it feels like everything is as factory specs should be ...(sarcasm)

Looks like you already completed your task. I have a 07’ Marlin purchased used. The boat was fully loaded however I’m not certain the transom rocket launcher/rod rack was factory. Upon re bedding screws and thru bolts everywhere I discovered the “Scientist” who mounted the transom rod rack used...

Bawhaha… hey Dan hope all is well. I missed my opportunity at a really really nice Duffy this past week.

Yamahas ... is that 240 total hours or is it since last ecm/flywheel change ? ... BTW nice boat

Good thread good advice !!

New coaming pad photos of my Marlin

Ahhhh ... the good ole' days. There were still Drive in theaters back then. Sneaked in the trunk of the car many times in the 70's

... No damage. Also as stated I purchased a brand new one, same outcome

Bermuda Triangle ....hahaha you read my mine Dan. Definitely a head scratcher. Compass(es) work fine until you place them in the mounting hole. I've looked all up in there to see if someone left or dropped a magnetized driver head or something, but have yet to see anything. Best I can tell is...

Nice job ... Any concern over starving the air to the generator with that switch in place of the vent ?

.... as an update I had purchased a new compass (throwing spaghetti) thinking the old one was bad. It wasn't. Same reaction observed. My belief is the steering unit is the culprit. I had asked the local electronics guy if he had a Degaussing tool ... His response : What's that ? At that point I...

Something doesn't make sense about the story ... if the boat was pushed against the rocks which punched a hole in the hull and sank why didn't the occupants crawl up on those same rocks to safety ?

Thanks all … gonna scope it out this weekend. Anyone do it in the slip or pull the boat ?

My cables are getting sticky tight. Anyone here tackle that job or have it done before ? 2007 Marlin with F 250’s

Dremel tool, tape , sandpaper and waxed gelcoat would do the trick for the best match. You could mix your own or Grady sells it to match (somewhat). That small of a job I would mix my own.

... engine hours in conjunction with the price might entice the right species in the chum slick. IMO the two most important bits of info

Have seen many issues reported about the Fusion units. Rebooting and resetting etc. sometimes it works only to reoccur the next day. I have the MS-RA205 in a center console that never gets wet and was installed professionally. Boat is stored indoors. This year at start up etc. the only thing I...

Same deal here with the 4 group 27’s set up at factory. Had AGM’sand swapped them out for higher CCA Deka lead acid dual purpose. Working with my electronics guy and also my Yamaha tech. Will post up when we conjure up a solution