Search results

Looks like it. But in Australia. https://www.menacemarine.com.au/premium-bait-board-4-rod-holders-2-mounts?gclid=EAIaIQobChMIrs3pvbr_8gIVCJlmAh2ZlAbgEAQYByABEgKPuPD_BwE

Not yet. Was supposed to be here in the beginning of August. Coming with the next boat shipment which has been delayed. So now the second week in October. What you require is in my post above.

No. But I want one. Didn’t realize it had a spot lock function. Not needing an electric motor, batteries and cables would pay for about half. Gotta start saving my pennies for when I re-power.

Outside under the helm. Sit on the floor and look up.

Mine is up under the console. (2006 228)

Check that your trailer is designed for drive on. Some aluminium trailers with bunks are float-on only. Driving on can damage the trailer.

I ceramic coated the non skid. It’s a bit more slippery than the chalky non-skid but no more than new non-skid. It’s so easy to clean. Hose off and go over with a microfibre cloth and mild detergent. No scrubbing required.

Got in a week’s holiday between lockdowns.

I wouldn’t be surprised if it bow rail would fit as is. The Gulfstream and the Seafarer bow pulpit, bow rail extensions are the same item.

Spreader lights and dome lights work. Spotlight and remote work. White wire hanging above id from the loud hailer which broke off during transit and I am not using. The black went to the fuse board. The white and red to the short brown wire above the fuse board. Looking at the cut crimp ends on...

I connected them today. Haven’t worked it out yet. Further investigation needed. Thanks for the replies.

When I imported the boat the radar mount was removed. That meant the radar, anchor light and loud hailer were disconnected. I thought these wires had something to do with the radar as they are not for the loud hailer or anchor lights. When I remounted the radar it worked without these wires...

Me too.

My 2006 has the J hooks and 2 press studs under the top roll of the cushion that clip onto 2 studs on the top of the transom. Very easy to remove.

New style stripes and nameplate.Grady dealer. Matching existing stripes. Hullstripes.com. Matching existing nameplate. Discontinued decals is a good place to start. A hair dryer on hot can help remove stripes depending on how old they are.

My 228 is the first boat I’ve had with trim tabs. I played around with the tabs for a while for bow up and down but went back to using the motor and using the tabs to counter any lean due to cross wind etc.

Google “chain sock”.

2 spares as well.

No new glass or gelcoat. Did it all myself. I machine compounded the gelcoat with areas of wet sanding where oxidization was worst and then ceramic coated it.

Have you checked the fuel lines under the cowling for kinks blockages, etc? Had a similar issue. Was a kinked fuel line coming off the under cowl, fuel/water separating filter.