Search results

Yes, that panel is removable. It has plastic snaps on the back. To remove the panel, gently pull it off along the edges. When you're done, push it back on. Be sure to push all along the panel, so it is securely in all of the snaps. Pay attention to which edge is the top and which is the bottom.

Hi Blake, my profile photo shows it on the boat. I will have to take some photos of the install and upload them.

That makes sense. Yes, I have the keypad. You can use it to adjust the tabs at any speed in manual mode; similar to regular trim tabs. That is what I used to get home when the Auto setting kept shutting off without warning. You can use the SK app on the MFD or the keypad to adjust in Manual and...

Seakeeper's tech support told me that the new update requires a strong, reliable GPS signal that maintains an EPE(M) of less than 3.0, so the software uses GPS data to control and adjust the vessel's attitude. Prior to the 2026..4.1 software update, my system worked fine using the internal GPS...

Yes, it is on the 216. I love it; it's a game changer. It makes the boat feel and ride like a much bigger boat, and it gets on plane much faster. It should be a factory option, as Regulator Marine and other boat builders are offering. The SKR system and the trolling motor have made my little...

From what I understand, speed, GPS accuracy, and the ability to account for changes in speed and direction are inputs the system relies on to make the numerous adjustments it makes per second. An EPE(M) of 3.0 and above can cause the SKR system to switch from Auto to Manual mode. Prior to the...

I had mine setup using the internal GPS antenna, but it wasn’t accurate enough for my Seakeeper Ride system to work properly after Seakeeper’s latest update. I installed a Garmin GPS24xd external antenna with heading sensors and it is a huge improvement. It went from an EPE(M) of 3.5-4.25 to...

You will get different gauge sizes depending on the voltage of the system. I believe you mentioned you were going to run three 12-volt batteries to make a 36-volt system. Using the circuit length and amperage you provided with a 36-volt system, the calculator comes up with 8 AWG wire (UL 1426...

You should base your circuit's wire length on the total length of your circuit (positive + negative). Here is a great calculator you can use. https://boathowto.com/wiresize/abyc/

Hi Delaware, sorry about the delay. The interior console has a height of approximately 4'8"

Hi Delaware Troller, my 216 is at the shop getting the Seakeeper Ride system installed. Once I get it back, I will measure the inside console height for you. I do not believe it will accommodate a 6' rod, but may accommodate a 5-1/2' rod stored diagonally. I believe the interior console height...

This is the electronics package that I ordered for my Fisherman 216: Dual Garmin GPSMap 8610xsv Chartplotters Garmin GMR Fantom 18x Dome Radar Garmin GT51M-TM Transom Mount Transducer Garmin VHF 215 with AIS Marine Radio Garmin AIS 800 Black Box Transceiver Three more weeks until it arrives...

That looks clean! I like how you hid the receptacle. I should have the boat in a few weeks. Once I get it and can see what I am working with, I will most likely have more questions. Thank you, I appreciate your insight and help.

Thank you for sharing that info. There isn't a lot of information available with trolling motor installs in the 216. What did you have to do to bolt down the mounting plate? What batteries did you go with? Are they in the console?

Hello, the boat and trolling motor install look great. I recently placed an order for a 216, and expect the boat to be delivered in a few more weeks. I want to install a trolling motor, as well. The local shop is recommending the 90" Kraken. Would you mind sharing with me how the 72" model has...