Search results

I am curious to see what the demand is for the new 251 coastal explorer ... shallow draft, low gunnels, "bay boat " In looking at the pictures above, PNW, I don't see any CC's or DC's !!! LOL They must all be out fishing !!!!

Follow the market ..... Grady got to this point for leading the market, not following !!! Offer a well made product and offer a product that everyone else doesn't make..... The market is flooded with manufacturers producing CC's and DC's .... Highly competitive...... Grady has pulled...

I wonder if by catering to the market, they are loosing a big part of the market .... They have eliminated the 24-26 foot WAC market from their product line. The 20 over nighter was my first WAC .. then the 24 offshore... and now a marlin300.... The 258 Journey was a great model to fill that...

In reference to the post about the air conditioner ...... I thought I was going to have to replace my original Marine Airrr unit ... After a LOT of research , I found that the best fit was as you installed.... Mermaid 9K BTU ( I wound up repairing the old unit ..) The Mermaid unit fits the...

Both my 2001 and 2007 Marlins had the isotherm 49 factory installed ....

Unless I read it wrong, bit it seams that Grady is offering only 3 WAC models ... 20' -23'-30' ..... I don't know how smart that is ?? They started the trend in WAC's and now leaving much less in the possible choices. I have owned 4 GW's and all were WAC's. A friend wanted to buy a New 258...

I don't see that boat with 150"s ..... My 240 offshore had twin 140 loopers and finally repowered with 150 ocean runners ...they were just right for that boat ..... I think i would go to at least twin 175- 200 's......

keep something in mind for accessories or components that are high amp draw...... A poor of loose connection can give a good voltage reading. But not supply enough amperage. sometimes the "telltale" is that the voltage reading will be slightly below normal and tested voltage at the...

That is a common electrical terminal ... available readily ... Amazon, E bay ... any vendor that sells wiring connectors

I spent a lot of time researching this for my 2007 marlin .... I wound up getting the original unit repaired, .. I removed it from the boat and brought it to a marine air ( dometic) service guy in NJ. So Far - so Good !!.... I was going to replace it with either a Mermaid or Mabru unit ...

remove them and use finishing washers

Would you ship ?? And how much do you want for it ?? sorry for the delay ... I am trying to keep the helm remote which is very limited as to usable radio models .. With the radio on the opposite side of the helm, trying to run a harness for a new remote is almost impossible ...

I don't know why Grady would not have just isolated the house batteries so that the starting the motors or generator could never be effected by house draw current . ... My 2001 Marlin Battery wiring seamed so direct and so simple ... ( Maybe they saved the cost of an extra switch as the 2001...

Want to buy Kenwood KTS- MP-400 or KTS 300 in Good working condition ttabbacchino@aol.com

My used 2007 marlin, with Grady power steering , had a Raymarine e127 when I purchased it .... i wanted auto pilot .. . After doing a lot of research and picking the brains of several marine electronics installers and a dealer/ technician that has never done me wrong , I went with the...

Thanks very much .... informative and simple

LOL .... one size does not fit all !!! .... For me on my "o7 Marlin and 5'5"" height ..... this worked Standing >>>A milk crate with a 3/4 inch plywood cover with 3/4 inch of foam glued to it ... (storage too) Sitting >>>> removed the original seat pedestal and installed a taller one ...

Look for rotted aux charging wires .... as previously stated mine were also rotted in the middle of the rigging tube

I am trying to figure out the, what I believe to be the Factory Battery Wiring on my 2007 Marlin. twin 250 Yamahas... 4 batteries, seams like 2 banks, Guest 2 bank charger.... 2 battery switches... Battery banks seam to be port aft and forward and Starboard aft and forward. Boat has a...

I boat out of Barnegat Bay and Barnegat Inlet , NJ .... out to 30/40 miles off shore ... I currently use Lighthouse 2 charts in my Raymarine e127 plotter .... Does anyone use anything better , ( C-map or Navionics )???? Any Advantages ??? Thanks