Search results

Thanks for the info.

Dr batts, I just purchased a 2007 305 with twin 300's. I have the original garmin 7212 gps map screens with radar and sonar. I am having a problem with the sonar only functioning to about 20 ft.nowalthough it seemedto work 3 months ago. Do you have any experience with Garmin sonar issues...

Hopefully you will come across the solution. We are anxious to find one also!

Jason, I think this cable will work if it is plugged directly in engine and you have a NEMA 2000 network. My motors and electronics are 2010. From what I have learned, I need to set up.a seperate NEMA network and then connect this go the Yamaha connector bar and finally go from the NEMA system...

I ordered the New England 3 strand from Partsvu. $188.95 with free shipping. Thanks

Thanks Bill. I have 8 braid line but have been unable to do the linevto chain splice. I am going with 3 strand since I can do this splice.

Thankz

Thsnks

Thanks for help

What is the best 1\2 inch 3 strand nylon to use with a Lewmar 700 winch on a 305 Express. I have 30 ft of 316 chain and just want to replace line with a 3 strand I can splice.

Food for thought! Thanks!

I agree that buying a few extra gallons is easy and safe for the novice. Thanks! Good idea to watch an expert, however, that might be difficult with the little boatyard I plan to use for the winter. Have you heard of blowing out the generator and ac with an air compressor?

Sounds like a good alternative!

Thanks. Sounds pretty complicated. I was thinking that the generator and ac might just back drain with the sea cocks open. The two Groco sea water strainers have drains on each which might be useful for emptying the systems?

I will have to discover how to get to the hot water tank! Thanks

I know it is months away but I like to get a handle on techniques before the time comes. I see how to drain the salt wash down lines but I am curious how to do the pressurized fresh water including the hot water heater. My first thought would be to use up all water in tank and then add a couple...

Thanks. Alot still to learn on maintaining these beasts. Appreciate your time and guidance!

Ok. This sounds good. The technique is to input the fogging solution directly to the inbound barb of the on engine gas filter. Sounds better than disconnecting gas suction lines in bilge. One question, though, what is the “vst?”

Thanks

Good info about connectors!