Search results

Let me know if this is still for sale. Thank you.

They are located below the two pie plates in the motor well. Tricky to reach.. I'm thinking about add rods to mine to make opening and closing easier. they have rods on the bigger Gradys...

Mike, I would offer $50 shipped to Clermont FL 34711. Thank you. Rob 352-408-2209

I have a a left handed powertech turbo14.5 X 17 4 bladé prop...if interested...I don't have a right hand prop... Rob 352-408-2209

hi. do you have the two mid section covers...kind of rectangular? Thanks Rob

Do you have the cavitation place part of lower unit? Not sure where one starts and one ends…Thank you. ROB

are these still for sale? Thanks Rob

I have a 2006 GW 180 and 2005 Marlin 300. On the Marlin I rarely if ever use the tabs and run the boat primarily with engine tilt and trim. The GW 180 is a different animal...It runs bow high to get on plane and with a 7.5 foot beam is tipsy loaded. Saying that I use tabs more on 180... You...

I have a 2005 Marlin 300. Use Teleflex extreme cables. 24' & 26' are sizes you need. You can confirm with GW. You may need to pull off starboard mid berth panels to help guide...Remove binnacle and pull from there...Electrical Tape (real good) new cable with electrical tape with about 12"...

Send your phone number and I will send some pictures. Thank you Rob

Send you phone number and I will text a picture! My number is 352-408-2209. Im heard out for a little while but can do it later. Thank you. Rob

Thank you!

Thank you!

I have an extra adjustable 2005 GW Marlin table post. I believe its made by Zwardvis (spelling?). Not sure if the one I have will work by I ma looking to sell it and get it out of my garage. Rob

My B744 works great...it only 600W so I want o add a second that will give me better definition at greater depths. I will just switch back and forth. I don't want to add another faring block so that's is why I'm looking at the flush mount. I think the 175M may be the one...

Yes the rear flats on both sides of the bottom of the boat that GW dedicated for a transducer in their design. However there is a flat inside the bilge as well where the transducer comes through as I recall...and where it bolts up.

OK Thank you. I have the smaller b744V holds at all speed but want more power/better read. So I need 20 degree angle B175 airmar for the flat? Do you remember where you mounted it on the flat - middle, front, etc...? What king of sounder are you using? I appreciate your help. Rob

thank you

Did you find out the dimension? I have a 2005 as well. Im looking to install another transducer on teh port side with more power. I run an airmar B744v on starboard side with faring block.- 600Kw it reads at all speeds. Looking for more power and flush mount transducer for the other side...

I have a 2005 Marlin. My main amp is mounted behind the tackle boxes under the captains helm seat. Pull out tackle boxes and and unscrew the box frame and remove. There is a shelf under the sink where the hot water heat sits. My JL Audio 600/6 sits on the shelf on the left. Stays dry and...