Search results

I really need some help with a laymans defintiion on how I could be told the follwing on a boat that ran fine 1 week ago. Basically I can't start the engine. The engine will turn but not turn over and run. I tried as many times w/o risking hurting other engine parts like starter. I took it...

I have some extra time for some maintenance and have been able to get everything I wanted done expect for two problems. My front Bilge breaker keeps tripping. I do know that I have left it running by accident on more than one occasion. Is the bilge pump fried? My steering wheel seem to...

OK..I ran into a low gas situation while far from a marine gas station but close to a land gas station. I bought a cheap plastic gas tank to transport the gas. WHile I was pouring in the cheap-ass gas nozzle came off into the intake and is now in my main tank. I have a 1998 Grady Voyager...

I recently installed a 5 Channel amplifier to my JBL Head unit. The amp is hooked thru the JBL's RCA hookups using Gound Loop Isolators on each channel. I also have XM thru the Garmin 3210 Bundle with the XM receiver installed in the overhead box and connected with "better than average" RCA...

I found out that I have neck issues that will keep me out of the water for a few weeks so my Striper season is over. That means it is time to complete some maintenance on my boat but unfortunately, my boat is kept in water and don't have a trailer to pull out to do some much needed work. I have...

I have an older Sitex sounder (came on a 1998 Grady) and have the operation manual but can't find any info on my question. The unit I have has a separate toggle for a narrow or wide beam that the transducer is plugged into and then a another cable that plugs into the unit. My question...

I was hoping a few folks could chime in on a question I have. I currently have a Garmin 3210 with Digital Sonar on a transom mount transducer. The Grady I have used to have a Sitex 106 with thruhull tranducer. The transducer cord and transducer are still installed. I don't think I can get...

I came across some very shallow water in the channel leaving the Lynnhaven basin going the alternate route to Long Creek on Sunday. I think I sucked sand in for a second. The overheat alarm went off after about 10 minutes while I was drifitng for flounder. Now tonight I went to the 1st Island...

Over the past 5-6 runs, engine has cut off at lease once when going full throttle. I can start right up and get going immediately after each time it shuts down. I have tried to pay attention to everything so when it happens, I have some info. These two seem to be the consistent things: 1...

Can someone set me up with a link on how to use the outriggers that came with boat. I have a set but dont have any idea where to start. Thanks in advance.