Search results

Sold

I have talked with two people and they measured the Todd 9994-144 gibbs and and they both came up with Very different measurements. I just ordered the 9994-144 gibbs from Fisheries Supply in Seattle; they are currently backordered sine 12-22. When they arrive well let you know if they fit.

That's is a good idea!!! I will look into that. My understanding that is that Delrin/Acetal Copolymer Plastic is the best material for wear & durability.

Thanks I will. It's looking like I might have to try to make some. Just talked with Todd and he took some measurements from a P/N 9994-144 gibb and it's to big. Back to the drawing board.

I can not find any manufacturer's name on handles. Here is what I have found. Grady White, below; does not think the Todd PN 9994-144 Bottom pics) are the same part as the one's on my 97 208

Here is a pic. of slider.

Have any luck finding the bushings and sliders? I am having the same challenge, not even sure who made the seat and slider for my 97 208.

I have a good used bimini top with front, side curtains,frame and mooring cover. I am in the Seattle,Tacoma area of Washington.

Thanks!

I am looking to replace the old windshield screw cover. It looks like it is about a 9/16" black, round tubing that just pushes into the channel and hides the screw that are used to secure the windshield to the boat. Any idea who sells it?

I decided to go with the Yamaha dual 704 control, keep it simple.

The Yamaha - 704 dual has the trim tab rockers mounted forward. The Seastar solutions dual has 4 rockers which 1 rocker switch I am assuming could be used to control kicker motor tilt? Am leaning towards the Seastar dual but do not have experience with any of this. attached pic. of the Seastar...

Looking for ideas how to setup my Adventure main and kicker controls. 97 GW Adventure 2003 Yamaha 200 four stroke, 2022 Yamaha T9.9 remote controls, electric start, power tilt. Seastar Hyd. Steering main motor. Seastar cable steer for the kicker. Thinking about Yamaha - 704 dual premium...

Trapper, do you have a picture of your kicker bracket mounted on your 208? I have a 97 208 with trim tabs and the Adventure fixed kicker bracket with a Yamaha 9.9 25" shaft. I am concerned that the bracket will hit the trim tab hydraulic cylinder before I can get the kicker low enough in the water.

I Really like that modification. That is a Must have! Thanks!

I have to admit drilling a hole through the bottom of the boat makes me a little nervous!

Here is a pic of my transom. I am little concerned about the trailer bunks being in the way if I don't load the boat just right. Do have a pic of your setup?

Anyone have any pictures where someone has added a hatch to this area? I Really like this idea! Would make a clean install for the transducer too.

I like that spot a lot better!!! With the hull transducer I understand you do not get water temperature? Is that an issue? PS I like the idea of more storage!

Here are a couple pics. Is the rectangle lid area where they would mount a fresh water tank? Looks like a lot more room to mount a transducer!