Search results

Here is an update, cleaned the injectors with pressure/seafoam rig & VST service... shes purring now! Thanks for the tips much appreciated https://www.dropbox.com/scl/fi/h2c7gh02ia3gu41bqs75l/IMG_3072.MOV?rlkey=s8b7srr2j4otmsw031futja2w&st=42cu6lcx&dl=0

Thanks for the feedback Denis, yes she's vibrating at idle then as you rev up get worse and worse and sounds like starving for fuel or air or something, going to dig in more after work & I will report back. All drive train looks good, prop, shaft, thrust washer, etc.

Hello, I am looking for some advise to see if anyone can see a smoking gun.. these are on my 2000 Gulfstream- 2011 port engine, troubles just started, 628 hours. Basically sounds like the motor is in limp mode, vibrating, etc. 2007 Stbd engine- runs great, 1436 hours The port engine seems...

thanks Mustang Great info

Hello~ Does any know where I can possibly get a replacement? Or maybe someone has made one from Starboard? Any info is appreciated! Thanks Justin

Hello! I have a 2001 23' Gulfstream with twin F150's & I wanted to replace the Command link gauges, they are a little tired and some difficult to read. A couple questions- 1- I found a few on E-bay but where is a good place to buy these square bezel guages? I need the 2 tachs and the 1...

this is what I would use! Groco bronze thru hull w/hose barb

thanks for all the replies & informaiton guys, much appreciated. Unfortunately there is not an old tranducer cable to use but I did receive this below from GW below & will give it go now that I know where the conduit pipe starts "Hello Justin, At the helm there is a starboard rigging cover...

Thanks for the reply, the fuel tank fill & vent and fish hold drain/thru hull are behind that pie hi It seems pretty far to run a snake from the dash pie hi all the way to that aft corner access, ill give it a go! thanks again

Hello! Im trying to run a transducer wire from the stbd aft corner up to the dash space. It looks like the throttle cables & main wire run is on the stbd side but I cant see exactly how the run is, do I need to remove the fuel tank deck hatches? There are no access hatches on the floor on...

Hi Rlloyd, I also have a 2002 232 Gulfstream and will be digging into his job this weekend. Where did you get the replacement plastic drains & 90 degree fittings? Also were you able to access the underside of the drain fairly easily through that small access door? Any information is appreciated!

Thanks Uncle Joe, thats a good alternative

Yes agreed! Thanks

Hello, I am looking to add a larger live well on my 232 Gulfstream maybe around 30-40 gallons. I am looking at these Pacific Edge Frp tanks, although very nice they are not cheap. I suppose you pay for quality. https://www.pacificedgetackle.com/ Was wondering if anyone has some recommendations...

I checked the wiring and someone got in there and hacked away.. So I ran some wires on deck back to each sending unit on each tank and connected them to the solid pink & the pink and black on the back of the fuel gauge & wallah is worked perfectly. The left row is the main tank which showed...

Great thanks for the reply, do you by chance have a wiring diagram so I can confirm all the connections are correct? I cant find anything online.

Hello~ I have a 2000 Grady Gulfstream 232 with a main tank & aux tank with the command link fuel gauge. Basically both vertical rows of black bars on the fuel gauge read the Aux tank only. I disconnected the pink & black wire on the Aux tank sender at the tank top & both rows go blank. When I...

good stuff guys thanks for all the useful info, Ky Grady now thats a gorgeous fuel tank ;) goals...

Thanks FirsttimeGrady on another note does anyone have a wiring diagram for this 6Y8-8356N-01-00 Fuel sender/GPS harness that plugs into the back of the Command link Speed/fuel guage? I searched around and could not find one. I think this might be wired wrong on my boat and may be the cause...

Great thanks for the tip, ill check the hub and connections, both tanks are completely full