Search results

Good morning all. I have a 375 Freedom and replacing the SureShade Control box that is tucked up inside. How do I remove the headliner with the three lights in it please? Looks like it has been done before if you note the "screwdriver" marks on the left side of the vinyl. I'd appreciate the...

Depending on where you end up docking in “southern florida” will have a dramatic effect on how much growth you get. There is a reason why you’ll see most boats your size up on the lifts around the canals along the waterways in Fort Lauderdale north & south. A private dock might seem like a...

Thank you - just didn’t want to dig around without checking first. Greatly appreciated.

Good evening all. I plead ignorance and can’t figure out how to remove this bolster. The cushion is on the Port side, stern access door of a 375 Freedom. I assume the holes on the bottom are for drainage. Do I just “muscle it up” since I can’t find any screws? Thanks for the help.

Just went through this as both a buyer and seller. Really depends on how complicated the boat is but a broker is your buffer and a good one will minimize the hit you take after survey. "Typical" fee around me is10%. The wrong buyer can cause a lot of brain damage and it's the brokers job to...

Thank you all - 295UV by sika did the trick.

We replaced the 12' section of stainless trim and reseated the rub rail. Other than a 1" chunk out of the plastic rail it looks great. Any reason I can't tint 4000UV or 4200 and just slowly build it up? Thanks again.

My rub rail was damaged. Took off and replaced the stainless after reseating the plastic trim. I did not replace the plastic and have a gouge about 1" x 1/2" I need to fill. (This is before picture.) As you may know - the rub rail is navy and not black. Does anyone know if there is a dark navy...

Who said you can't teach an old dog... I've always been concerned about rust or corrosion and actually avoid it. Thanks for the tip.

Good morning all. I measured my existing wipers and they are 28" long. There still seems like a lot of windshield that is not being wiped when running and I want to make sure 28" is correct before I order replacements. Thank you!

So SkunkBoat spanked my ass a bit and I appreciate it. This particular boat is new to us and it was our first long trip so I did intentionally push it to get a baseline, but that was too close. Fuel truck came to the house this morning and I took 297 gallons. That’s in addition to the 10 I took...

Lots of help guys – thank you. Bottom line is nobody knows for sure. Grady white service mentioned that the dealer might also have calibrated it. First time it happened to me on Saturday in very confused seas and it seemed to drop quickly. Truth be told I had Boat US bring me 10 gallons because...

Can’t seem to find the answer in the manuals, and I appreciate the help. When the low fuel warning flashes (bottom bar) on the Yamaha screen on the 375 Freedom - does anyone know how much fuel is actually left in the tank? Similarly, when the alarm starts buzzing - is it the same situation...

Bingo! Thanks JJF - I'll send a pic of it finished.

I don't mind drilling and using acorn nuts but I don't want to f it up. Thought of two of these spaced a few feet apart: https://www.amazon.com/dp/B08G13GRQG?ref=ppx_yo2ov_dt_b_product_details&th=1 Thanks for other suggestions.

This is my actual boat. Plenty of room at the rear of the hardtop for flags but I haven't found anything that works (aesthetically).

We often run multiple flags (dive, US, Bahamas). With no rocket launcher by the roofline - would you all share where you mount flags on the top of a 375 Freedom. The rod holders on either side of the hard top frame are too low and I need them for fishing. Many thanks!

Thank you.

Great information from you and wspitler. I'm clearly not running mine enough. Any recommendations on diesel additives? Thanks

That's a great thought. I followed the steps that DennisG01 suggested and everything worked so I guess I'll pull the panel. I will report back.