Search results

I have the 6 inch Beckson pry out deck plates. I ordered the DP6 o ring from Partsvu. It was a Beckson product. The o ring is about 1/4 the thickness of mine. Where can I get a thick one?

I actually thought about using the plastic but thought it would get brittle and crack over time.

Would you recommend using 4200 or 5200 when replacing the brass motor well drain tube?

This black box mounted on the front of the 5e is what I’m referring to. You can start and stop it from there.

I have tried running water in the deck drains and there was no accumulation in the bilge. I haven’t checked the anchor locker. I will. I also had a bow thruster installed and will check around it as well.

Which electronic box do you need? The one on the front of the generator?

Probably a Koehler 5e gas like I have in my 2003 Marlin. I’m removing mine and disposing of it because of the constant problems.

I had 2003 F225s on my Marlin. I dropped both lower units and scoped the exhaust tube. Both had corrosion. My marina replaced both with a kit from Sim Yamaha. One engine had beginning of corrosion on the bottom of the oil pan. It was cleaned, repaired with a weld and checked a year later. All...

I believe they are worn and leak water into the bilge.

I I have a 2003 Grady Marlin 300. These are the pop in plates, not screw type. The diameter of the opening is about 7 1/8 to accommodate the plate. It is original Grady equipment.

Does anyone know where to obtain a new o ring for the round access plates. My o ring diameter measured at 7 1/8 inches.

Goose here on Greatgrady had that done several years back on his Marlin 300. Same boat as mine. I asked him about performance and he stated it was ok up to about 2ft seas and low wind. I opted not to do it. My other friend bought 2 Rhodans so he could have one while the other was in the shop for...

I have a 2003 Marlin 300. I replaced my original Yamaha f225s with new Yamaha f250s in 2020. Kept hydraulic steering and cable shift and throttle. I believe in the less tech the better. I did install a bow thruster. Best money ever spent. I’d rather fish instead of spending time waiting on a repair…

I have changed to the 4 bank NOCO Genius and have never looked back or regretted it. I threw away my unreliable Pro Mariner.

How difficult is it to change the intake hose on the Marlin electric head unit?

What do you mean by it comes in and out. It isn’t removable. I’m not getting that statement.

My discharge is never open! I get my marina to pump it out when I fuel up.

I’ve been wondering if that was possible. I will run sealant. 5200?