I am updating the factory installed JVC radio/CD, which has a Prosec wired remote. Head unit is over the sink in the galley, wire bundle snakes off to speakers etc, and to the remote at the helm.
I plan to use the speaker wires as they are, and am hoping to ID the other wires in the bundle (anyone have any experience here?), perhaps to splice them as well.
I know the new wired remote will have to be run fresh, the technology has changed. I thought to pull the new cable through, pigtailed to the old, but I have no idea what I could be ripping out in the process.
Are the wire runs from the helm to the galley area accessible?
Or as an alternative, any thoughts on a new run for the remote wire which must be hidden ? The duct tape and carpet tack route has been nixed.
Thanks
I plan to use the speaker wires as they are, and am hoping to ID the other wires in the bundle (anyone have any experience here?), perhaps to splice them as well.
I know the new wired remote will have to be run fresh, the technology has changed. I thought to pull the new cable through, pigtailed to the old, but I have no idea what I could be ripping out in the process.
Are the wire runs from the helm to the galley area accessible?
Or as an alternative, any thoughts on a new run for the remote wire which must be hidden ? The duct tape and carpet tack route has been nixed.
Thanks