I am finally going to install tabs on my 208. I am looking at Bennett M120s and would appreciate any experiences you have had with installing tabs on a 208 (2001 model year).
Is there enough room under the swim platform for the actuator?
Where did you mount the pump? Port transom is full of other things.
There may be room on the starboard side near the batteries but probably not on the transom. How thick is the side glass just below the deck cap? Has anyone mounted the pump on the side?
I suppose I might be able to get the pump installed under the motor well but it is so hard to work in there and I want to keep the pump as dry as possible.
Where does the factory install the pump?
And finally, if someone has a similar installation to what I am proposing, how high off of the port and starboard board locker 'floor" did the hole for the hydraulic hose end up. I may need to move a pump and or filter bracket.
Thanks for the help.
Is there enough room under the swim platform for the actuator?
Where did you mount the pump? Port transom is full of other things.
There may be room on the starboard side near the batteries but probably not on the transom. How thick is the side glass just below the deck cap? Has anyone mounted the pump on the side?
I suppose I might be able to get the pump installed under the motor well but it is so hard to work in there and I want to keep the pump as dry as possible.
Where does the factory install the pump?
And finally, if someone has a similar installation to what I am proposing, how high off of the port and starboard board locker 'floor" did the hole for the hydraulic hose end up. I may need to move a pump and or filter bracket.
Thanks for the help.