Coaming Bolsters 1990 232 Gulfstream

[darkarcher]

I am building new Coaming bolsters for my boat and was wondering if anyone had the dimensions for these?

I couldn't upload the pic but mine has the drive platform so the motors are totally outside the cockpit.

Just 3 pieces the transom will be the longest and the 2 side pieces.

The boat is 1200 miles away and I want to build them here and install them when I get there.

Thx in advance. Any help/suggestions appreciated.

 

[darkarcher]

found a pic
My cockpit is the same as the one shown here.
http://www.boattrader.com/listing/1990-Grady-White-230-Walk-Around-102519099

 

[gwwannabe]

I couldn't get your link to come up. I have a '93 Gulfstream - 232G. I'm planning to replace mine this summer and the dimensions are as follows:
Rear: 88 1/2"
Sides: 58 1/2"
Height: 7 1/2"

My bolsters have webbing sewn into the bottom so water drains freely. I haven't removed them yet so I cannot tell you how they are mounted to the gunnel or the spacing of the those mounting points.

Gary 93 Gulfstream twin 140 hp Suzuki 4S

 

[darkarcher]

Thx gwwannabe

I am condidering using a composite type product like the Seadek coaming bolsters.

they come in 37' strips a pair for about 100.00 1 on each side and two across the back

Like these:
Link to Seadek Item