G Grog GreatGrady Captain Joined Sep 27, 2006 Messages 2,008 Reaction score 1 Points 38 Mar 4, 2009 #1 Anyone know what size the o-ring is for the fuel fill? Thanks
L Little Buddy Member Joined Dec 31, 2007 Messages 14 Reaction score 0 Points 0 Location ORANGE COUNTY CA Mar 5, 2009 #2 I think it may be a special size. A -223 is a little big and a -222 is tight. I put the -223 on and it is loose but works. When I get around to it, I'll try the -222.
I think it may be a special size. A -223 is a little big and a -222 is tight. I put the -223 on and it is loose but works. When I get around to it, I'll try the -222.
C crazygrady Active Member Joined Jan 27, 2009 Messages 44 Reaction score 0 Points 0 Location Atlantic Highlands Mar 5, 2009 #3 I was just thinking of replacing mine as well. Where is the best place to get them, West Marine, Boaters World or go to a Grady dealer.
I was just thinking of replacing mine as well. Where is the best place to get them, West Marine, Boaters World or go to a Grady dealer.
A Amigo Well-Known Member Joined Nov 12, 2005 Messages 183 Reaction score 0 Points 0 Location Saint Joseph MI Mar 5, 2009 #4 You should be able to buy them from an industrial distributor. Look in the yellow pages under "Rubber Products". They should fit a bit snug. A tiny bit of grease on them will not hurt and probably prolong their life.
You should be able to buy them from an industrial distributor. Look in the yellow pages under "Rubber Products". They should fit a bit snug. A tiny bit of grease on them will not hurt and probably prolong their life.
C crazygrady Active Member Joined Jan 27, 2009 Messages 44 Reaction score 0 Points 0 Location Atlantic Highlands Mar 5, 2009 #5 Thanks. I wasn't sure if they were a standard item in a marine store.
