Hardtop

['84_241_Offshore]

I currently own a '84 241 Offshore. Been searching for a Hardtop for years.
Found a donor '87 241 Offshore w/ a hardtop being parted out..........made an offer and the marina accepted.
Question: will the hardtop from the '87 fit the '84?........I think the answer is yes

 

[DennisG01]

Can't imagine why it wouldn't. I don't think there were any major hull changes in such a short time-span, was there? Take a look at the brochures on Grady's site and compare the two. And/or take measurements of the mounting points and compare to your boat. I'd be surprised if it didn't fit, though.

 

[seasick]

Its hard to tell but often the rear supports are similar or identical but the front may be different if the windshield design changed. I would think that Grady would know if the mold used for the 84 deck is the same one used for the 87 deck. In the worst case, a fabrication shop probably can 'tune' up the support attachment points

I would recommend that you get accurate measurements of the mounting points off of the 87 (and pics) so that alignment on the 84 goes smoothly.