I have a 2005 Journey 258. I was just reading the User manual and it says "The rigging compartment is located aft of the fuel tank compartments. This enclosure is functional for rigging ignition protected accessories and for better passage to rigging components located aft of this compartment. This compartment contains two flats for mounting transducers. The rigging hatch and mounting screws must be sealed with silicone sealer after rigging is complete. If the lid is removed it must be resealed to insure watertight integrity."
I am interested in the flat areas for mounting transducers. The fuel tank compartment goes all the way to the bulkhead behind the flip up passenger seat. The bulkhead has a door to access the batteries/bilge pump. But given the description above I don't believe it is talking about this area. There are two circular ports in the transom well (pop off type I believe, going from memory since I am away from the boat). Is this where the transducer flats are located? As anybody used these flats for an in-hull transducer?
I am interested in the flat areas for mounting transducers. The fuel tank compartment goes all the way to the bulkhead behind the flip up passenger seat. The bulkhead has a door to access the batteries/bilge pump. But given the description above I don't believe it is talking about this area. There are two circular ports in the transom well (pop off type I believe, going from memory since I am away from the boat). Is this where the transducer flats are located? As anybody used these flats for an in-hull transducer?