I have an 89 228G. I'm looking for a replacement valve for the livewell/washdown. This is the valve under the rod holders near the floor that has a single 4" long handle. Where do I find a valve that will match up?
livewell/washdown valve
- Thread starter garyd
- Start date
I'm not sure about 1989, but in 2004 they used Apollo valves. Does it look something like this? http://www.apollovalves.com/products/by ... ecific/263
Fishtales
Well-Known Member
- Joined
- Jan 31, 2005
- Messages
- 7,612
- Reaction score
- 1,187
- Points
- 113
Hi,
See if you can get the pipe size that connects to the value and then match it up at a good marine hardware store. The biggest thing is to get a quality marine grade ball valve made from bronze or DZR brass (look for a CR marking on the seacock). CW617N marked valves have high zinc - ok for domestic water or fresh water environments; not salt water.
You could always check with GW Customer Service via the net and see if they have information.
See if you can get the pipe size that connects to the value and then match it up at a good marine hardware store. The biggest thing is to get a quality marine grade ball valve made from bronze or DZR brass (look for a CR marking on the seacock). CW617N marked valves have high zinc - ok for domestic water or fresh water environments; not salt water.
You could always check with GW Customer Service via the net and see if they have information.