scupper size in the Islander

[1st grady]

Does anyone know the scupper size for the Islander cockpit deck drains? I would like to order some but can not get into the boat at this time (4- 5 feet of snow piled all around) If I do not get a reply I will just have to start digging.
thanks

 

[ocnslr]

I don't know the size, but the boat is in the water (big smile) at our condo dock. It's about a four-minute walk and I am going there tomorrow.

So, what dimension do you need? The OD of the flange on the top? or something else?

Brian

 

[1st grady]

ocnslr,

OD of the flange would probably be good. That would most likely determine the correct diameter of everything. Maybe a hose OD as well. I can then determine the barb size. I am thinking that it should be a 1 1/2" barb to accept a 1 1/2" ID hose.

My plastic flange measures 2 3/4" OD.

Thanks

 

[ocnslr]

The OD of the flange on the plastic deck fitting is 2-5/8".

Couldn't get to a hose barb section to measure it.

Probably worth a call to the factory. They will look it up and let you know for sure.

Brian