Simrad Autopilot AP 11

[Shady Grady]

I have a recently purchsed 01 Marlin. I recently had the genset repaired. Prior to and while the genset was out, the AP was working fine. After genset was reinstalled, the AP will not power up. I've checked all the fuses I can find, and all appear to be ok. Also as I discovered this over the wekend I have not yet gone back to the company that repaired the genset. I will contact them next week. In the mean time any suggestions as to where to start troubleshooting?

 

[jimmy's marine service]

if it won't "power up" then you're lacking either power or a ground...you claim you checked the fuses,did you verify you had power at the fuses ???

 

[Shady Grady]

No, I only quickly looked at the fuses. I am still in the process of discovering where all of the fuses and power sources are located, the DC distribution panel and the fuse teminal under the helm were obvious places to start. I have not yet located where the AP main control unit is located. I plan to find it and start tracing the power source from there. I was hoping someone out there knew of something that might have been directly related to the genset service.