Sorry if this seem like a silly question but, I have only ween working with the epoxy in thinned out batches.
I want to make a couple round epoxy plugs to fill in some holes in wood, about 1 in thik and 2.5 in around. I plan on routing the mold out of wood and putting plactic in it for a release after I mix and pour it in.
Using 105 resin and 206 slow hardner and some 404 filler @ 70 deg will this get too hot and melt the plastic or burn anything. Only reason I ask is, I plan on pouring this in and dont want to have a fire or anything smoking while I am sleeping.
I want to make a couple round epoxy plugs to fill in some holes in wood, about 1 in thik and 2.5 in around. I plan on routing the mold out of wood and putting plactic in it for a release after I mix and pour it in.
Using 105 resin and 206 slow hardner and some 404 filler @ 70 deg will this get too hot and melt the plastic or burn anything. Only reason I ask is, I plan on pouring this in and dont want to have a fire or anything smoking while I am sleeping.